Notice PHILIPS HD 5405

« ip stop GLid of coffee jug HCoffee jug IHotplate JOn/off switch with pilot light KMains cord LMeasuring spoon Important Read these instructions for use carefully before using the appliance and save them for future reference. ?Check if the voltage indicated on the appliance corresponds to the local mains voltage before you connect the appliance. ?Do not use the appliance if the plug,the cord or the appliance itself is damaged. ?If the mains cord is damaged,it must be replaced by Philips,a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard. ?Do not place the appliance on a hot surface and prevent the mains cord from coming into contact with hot surfaces. ?Never immerse the appliance in water or in any other liquid. ?Unplug the appliance: -if problems occur during brewing; -before cleaning it. ?Keep the appliance out of the reach of children and do not let them play with the appliance. Prevent children from pulling at the mains cord.Do not let the mains cord hang over the edge of the table or worktop. Before first use 1Clean the detachable parts (see chapter 'Cleaning'). 2Let the appliance run once without filling the filter with ground coffee (see chapter 'Using the appliance'). When you use the appliance for the first time,make sure the water tank is only half full. ENGLISH6Using the appliance Brewing coffee 1Make sure the lid is on the water tank. 2Open the lid of the water tank cover and fill the water tank with fresh,cold water (fig.2). -Make sure you fill the water tank to a level between the minimum and maximum indication marks. -Always close the hinged lid of the cover after filling the water tank to allow the appliance to function properly. ?The graduations on the left are for large cups (120 ml). ?The graduations on the right are for small cups (80 ml). 3Swing the filter holder support out of the appliance (fig.3). 4Take a paper filter (size 102/1x2) and fold the sealed edges to prevent tearing and folding (fig.4). 5Put the filter in the filter holder. 6Put ground coffee (filter-fine grind) in the filter (fig.5). -For large cups:use one heaped measuring spoon of ground coffee for each cup. -For small cups:use one level measuring spoon of ground coffee for each cup. BUse filter-fine ground coffee.If you grind the coffee yourself,do not grind it to a fine powder. 7Swing the filter holder support back into the appliance (fig.6). 8Place the jug on the hotplate (fig.7). Make sure the lid is on the jug. If the lid has not been placed,the drip stop will block the outflow opening of the filter and the coffee will not drip into the jug. 9Switch the appliance on by pressing the on/off switch (fig.8). 10When all the water has passed through the filter,you can take the jug out of the appliance (fig.9). 11After having poured coffee,put the jug with the remaining coffee back on the hotplate to keep it hot and to preserve its flavour (fig.10). ?However,coffee is at its best right after is has been brewed! (fig.11). Drip stop The drip stop prevents coffee from dripping through the filter onto the hotplate when you: -remove the jug from the appliance for a moment (max.30 seconds) during the brewing process. -remove the jug after making coffee. After drinking coffee 1Swing the filter holder support out of the appliance (fig.12). 2Lift the filter holder with the paper filter out of the filter holder support (fig.13). 3Throw away the used pa... »