Notice DORO Matra Phone Easy 311C

« e socket on the left- hand side of the telephone q. 2. Connect the telephone line cord to the socket at the rear of the telephone T, and to a telephone network wall socket. 3. You will hear a click when the modular plug is correctly in place. 4. Lift the handset and listen for the dial tone. Your telephone is now operational. Wall mounting The telephone can be wall mounted using two screws positioned vertically at a distance of 100 mm, the screws should ?t into the ‘keyholes’ on the back of the telephone. Remove the hanger hook (please refer to diagram on page 2) by pushing it upwards, then rotate it 180 degrees and replace it Hearing Aid compatible This telephone is hearing aid compatible. Select the T mode on your hearing aid to enable this feature. Mute button Press and release z to mute the handset microphone during a call, the light next to the button will ?ash while the microphone is muted. Press and release z again to continue with your telephone conversation. Redial button If the number dialled is engaged or you wish to dial the last number called lift the handset and press and release r. Redial will not work if the number dialled was from memory (i.e. M1, M2, M3 or 0-9). Recall Access to additional network services can be gained by using the recall button R, * and # keys. Contact your network operator for more information. Press the recall button R followed by the extension number to when connected to a PBX (TBR only).2 English Memory The telephone has 3 one-touch and 10 two-touch memories. One-touch memories are stored in M1, M2 & M3, two touch memories are stored using the telephone keypad digits 0-9. Storing One-touch Memories 1. Lift the handset, press and release P (ignore anything you hear in the earpiece). 2. Select a memory location M1, M2 or M3 by pressing the corresponding button. 3. Enter the telephone number to be stored (up to 21 digits). 4. Press and release P again. 5. Replace the handset. The number is now stored. Dialling using One-touch Memories 1. Lift the handset and wait for a dialling tone. 2. Select a memory location by pressing the corresponding memory button (M1, M2 or M3). The stored number will now be dialled. Storing Two-touch Memories 1. Lift the handset, press and release P (ignore anything you hear in the earpiece). 2. Press and release m. 3. Select a memory location by pressing one of the keypad number buttons 0-9. 4. Enter the telephone number to be stored (up to 21 digits). 5. Press and release P again. 6. Replace the handset. The number is now stored. Dialling using Two-touch Memories 1. Lift the handset and wait for a dialling tone. 2. Press and release m. 3. Select a memory location by pressing the relevant keypad number 0-9. The stored number will now be dialled. Press and release r if you need to insert a pause in a telephone number. The name or number stored in memory can then be entered on the memo list if wished. If a stored number changes, follow the procedures above entering the new number in the same location as the old one.3 English Earpiece Volume control During a conversation press and release either v to increase or V to decrease the earpiece volume. Ringer 1. Lift the handset (ignore anything you hear in the earpiece). Press and release P. 2. Press and release #. 3. Select a ringer and melody by pressing the number keys 0-9 (please refer to the table below). 4. Press and release... »