Notice AXIS 215PTZ

« 1 inner bracket, 1 outer bracket Plastic domes x 21 x for surface mounting 1 x for drop ceiling mounting ScrewdriverResitorx T20 Screw kit•1 x safety wire 1m (3.3 ft) •2 x plug 30x3.4-4mm •2 x screw ST4.2x38 •4 x screw M4x10 •1 x screw M4x4 •2 x screw M4x10 resitorx TemplateUse to mark positions for surface/drop ceiling mounting CDAXIS Network Video Product CD, including product documentation, installation tools and other software Printed MaterialsAXIS 215 PTZ Installation Guide (this document) Axis Warranty Document Important! This product must be used in compliance with local laws and regulations.Page 4AXIS 215 PTZ Installation Guide Hardware overview Surface mounted unit Drop ceiling mounted unitAXIS 215 PTZ Installation GuidePage 5 ENGLISH ENGLISH Weights •Camera: 0.60kg (1.32lb) •Drop ceiling mount 0.54kg (1.19lb) •Drop ceiling cover 0.12kg (0.26lb) •Surface mount cover 0.13kg (0.29lb) •Power adapter, including mains cable: 0.43kg (0.95lb) Connectors & buttons Mounting The front position The AXIS 215 PTZ can pan (swivel) ±180° from position 0°, i.e. the metal tab to the left of the connectors, as illustrated above. This position can be thought of as the “front” of the camera, and is the point to which the camera will return whenever it is (re)started. ! IMPORTANT! - The AXIS 215 PTZ is designed for indoor and outdoor use. To use the camera outdoors, it must be installed in an approved outdoor housing. Please see www.axis.com for more information on outdoor housings. Do not use the camera’s dome bubble if it is to be installed in an outdoor housing as the use of two dome bubbles will reduce the image quality and cause image blurring. Power connector (see page15) Network connector (see page15) I/O terminal connector (see page15) Status, Network & Power Indicator LEDs (see page16)Audio out Control button Audio in Position 0°Page 6AXIS 215 PTZ Installation Guide The AXIS 215 PTZ can be mounted in 2 different ways: •Surface mounted on a hard ceiling, in which case the unit is fastened directly to the ceiling material •Recessed in a drop ceiling, which involves cutting a hole in the ceiling and using the supplied drop ceiling mount Surface mounting If the required cabling is also surface mounted, the cables should enter via the removable cable inlet on the large plastic dome cover. 1.Use the supplied template to mark out the positions for the screws that will fasten the camera to the ceiling. If required, drill holes for the supplied mounting plugs. 2.Use the 2 supplied 4.2x38 screws to fasten the camera to the ceiling. 3.Connect the camera to the network using a shielded network cable. 4.Optionally connect external input/ output devices, e.g. alarm devices. See page15 for information on the terminal connector pins. 5.Optionally connect an active speaker and/or external microphone. 6.Connect the supplied indoor power adapter to the power connector. 7.Using the supplied screwdriver, attach the large dome cover, using the 2 M4x10 resitorx screws. Notes: •When power is applied, check that the indicator LEDs indicate the correct conditions. See the table on page16 for further details. •The dome cover can be fitted with the clear or the smoked plastic glass. See Replacing the dome glass, on page 9. Cable inlet 4.2x38mm screw M4x10 resitorx screwAXIS 215 PTZ Installation GuidePage 7 ENGLISH ENGLISH Drop... »