Notice SAITEK P880 Dual Analog Pad

« g any 3rd party software you create a restore point to return to should you encounter any difficulties. Windows®XPusers can do this by clicking on Startfollowed by Programs, then Accessories,System Tools and finally on System Restore. In the window that appears select Create a restore pointand then click on Next. You will be prompted to supply a name for this set-up. Should you then encounter any difficulties during the installation process you can follow the same path to restore your PC to its pre-installed state. 1With your computer switched on, close down any programs that are currently running and insert the Saitek Smart Technology CD into your CD-ROM drive. 2When the Introduction Screen appears, click Install Softwareto continue. 3When the Welcome screen appears, click Nextto continue. (If the CD does not run automatically, select Start from the Windows® Taskbar, then Runand type D:\Setup.exeand click OK- where D:\ is letter of your CD-ROM drive). 4After reading the Disclaimer, select theI accept the terms of the Disclaimeroption and click Nextto continue. 5At the DriverSetupscreen, plug in your controller and click on Next. 6At the Driver Setupscreen, click Nextto test your controller. 7When the SaitekController screen appears, try out all your controller’s buttons and controls to show that it is working properly. When you have finished, click OK. 8At the Software Setupscreen, select Do not install the SST Programming Software and clickNext. The Programming Software can be installed at a later date by following instruction (B). below 9At the Registrationscreen, select Check this box to register now and follow the on-screen instructions, or you can choose to select this option later. 10Click on Finishto complete the installation. P880 Dual Analog Pad Manual.qxd 20/04/2004 16:27 Page 3B) Drivers and Programming Software For Advanced Users 1Follow points 1 – 7 of the install procedure in A),then at the Software Setupscreen, select Install the SST Programming Software and click Next. 2In the following Software Setupscreen, click Nextand follow the on-screen instructions. At this point you will be asked to install such features as the Saitek Magic Mouse,HID-compliant mouse, Saitek Magic Keyboard andHID Keyboard Device(these are what XP calls the various elements of your Saitek controller). Continue to click on Nextand Finishto accept the installation until the Registration screen appears. 3At the Registrationscreen, select Check this box to register now and follow the on-screen instructions, or do not select this option and register later. 4Upon completion of the installation, you have the option to Run Profile Editor, which will give you a view of the 3D programming environment. If you do not wish to see the Profile Editor at this point, just uncheck the box and click on Finishto complete the installation. INSTALLATION FOR USERS OF WINDOWS® 2000 A) Drivers Only For Typical Users 1With your computer switched on, close down any programs that are currently running and insert the Saitek Smart Technology CD into your CD-ROM drive. 2When the Introduction Screen appears, click Install Softwareto continue. 3When the Welcomescreen appears, click Nextto continue. (If the CD does not run automatically, select Startfrom the Windows® Taskbar, then Run and type D:\Setup.exe and click OK - where D:\is letter of your CD-ROM drive). 4After reading the Disclaimer, select the I accept the terms of the Di... »