Notice D-LINK DKVM-2KU

« KU. Attach your computer’s 6-pin PS/2 male mouse connector to the DKVM-2KU mouse port. Make sure that all your computers are turned OFF before installing the DKVM-2KU to avoid mouse and keyboard errors when booting up your computers.3 Installing the DKVM-2KU Attach the DKVM-2KU‘s monitor cable to the VGA port located on the back of your computer case. Attach the DKVM-2KU’s mouse cable to the PS/2 mouse port located on the back of your computer case. Attach the DKVM-2KU’s keyboard cable to the PS/2 keyboard port located on the back of your computer case. Type A Power ON all your attached computers after you have completed the DKVM-2KU installation. The following steps below apply to both the computers that you are using with your DKVM-2KU. Note: In case you’d like to share USB device(s), attach your USB Hub or device’s (USB A type connector) to the console port of the DKVM-2KU. After that, attach the DKVM-2KU‘s built-in USB cable to the USB port located on the back of your computer case.4 Installing the DKVM-2KU Once properly installed, the keyboard, mouse, VGA monitor and USB device(s) will be connected with DKVM-2KU as below illustration:5 Switching with the DKVM-2KU The DKVM-2KU features a Select Button located on the front panel and keyboard Hot Keys to switch quickly and easily between both your computers. Select Button You can also use your keyboard to switch between your computers. Press the Scroll Lock key twice to enter Hot Key switching mode. A beep con?rms that the Hot Key mode is activated. Hot Key Menu Scroll + Scroll + F1 : Switches console keyboard, mouse, monitor and USB device to PC1 simultaneously. The PC1 LED will be a solid light then. Scroll + Scroll + F2 : Switches console keyboard, mouse, monitor and USB device to PC2 simultaneously. The PC2 LED will be a solid light then. Scroll + Scroll + 1: Switches to PC1 without USB device’s signal. The PC1 LED will blink. Scroll + Scroll + 2: Switches to PC2 without USB device’s signal. The PC2 LED will blink. Scroll Lock + Scroll Lock + S : Activates Auto Scan Mode. Each computer will be scanned every 10 seconds. press the space bar to exit Auto Scan Mode.6 Troubleshooting Tips Keyboard If your keyboard is not functional, not detected, or there is a keyboard error on boot-up, check the following: •Make sure that the keyboard is properly connected to the computer and to the DKVM- 2KU. Check that the keyboard is plugged into the correct PS/2 keyboard port and not the PS/2 mouse port. •Verify that the keyboard works when plugged into the computer directly. You will have to shut down your computer ?rst to do this. •Read your motherboard documentation and make sure that the PS/2 keyboard’s IRQ is enabled. This can be set for most computers in the BIOS setup. •Try using a different keyboard. Mouse If your mouse is not functional, not detected, or there is a mouse error on boot-up, check the following: •Make sure that the mouse is properly connected to the computer and to the DKVM-2KU. Check that mouse is plugged into the correct PS/2 mouse port and not the PS/2 keyboard port. •Verify that the mouse works when plugged into the computer directly. You will have to shut down your computer ?rst to do this. •Read your motherboard documentation and make sure that the PS/2 mouse’s IRQ is enabled. This can be set for most comp... »