Notice LINKSYS PLE200

« le of Contents Installation (English) ................................................2 Installation (Deutsch) ...............................................5 Instalación (Español) ................................................8 Installation (Français) .............................................11 Installazione (Italiano) ............................................14 Installatie (Nederlands) ...........................................17 Instalação (Português) ............................................20 Contact Information ....................................................232 Installation (English) NOTE: If your computer does not have Microsoft .NET Framework already installed, the Setup Wizard will install the software. Insert the Setup Wizard CD-ROM into the CD drive. The Setup Wizard should run automatically. If it does not, go to the Start menu and select Run. In the field that appears, type D:\setup.exe (if “D” is the letter of your CD drive) and press Enter. The Language Selection screen will appear. Select the appropriate language and click Next. On the Welcome screen, click Setup to begin the installation. A. B. C. Insert the CD-ROMInsert the CD-ROM Language Selection ScreenLanguage Selection Screen Welcome ScreenWelcome Screen3 Installation The End User License Agreement screen will appear. If you agree and want to begin the installation, click Next. The Preparing to Install screen will appear briefly, followed by a STOP screen. At this point, connect one end of an Ethernet network cable to the Ethernet port of the Adapter. Connect the other end to an Ethernet port on the computer running the Setup Wizard. Before plugging in the Adapter, write down the Device Password printed on the unit. Plug the Adapter into an electrical outlet and then click Next. IMPORTANT: Because the Adapter sends data over the power lines of your residence, Linksys recommends that you plug the Adapter directly into an electrical outlet. The Adapter has its own power filter for protection against surges. D. E. F. End User License Agreement ScreenEnd User License Agreement Screen ConnectConnect Plugs directly into outlet Connection to a Desktop Computer Plugs directly into outlet Connection to a Desktop Computer4 Installation The Install Configuration Utility screen will appear and copy the necessary files to your computer. After the files have been copied, the Congratulations screen will appear. Click Online Registration to register the Adapter at www.linksys.com/registration (Internet connection required) Click Exit to close the Setup Wizard. Hardware installation is complete. If you have more than one PLE200 (PLK200 is a kit containing 2 PLE200s), connect the additional Adapter(s) now. Be sure to use the Configuration Utility (Accessible via the PLE200 Utility icon on your desktop) to configure the Adapter(s) and change the default network password. The default network password (HomePlug AV) should be changed to a new password on all devices. For details, please refer to the User Guide located on the CD-ROM. For warranty, regulatory, user information for consumer products covered by EU Directive 2002/96/EC on Waste Electric and Electronic Equipment (WEEE), and specifications, refer to the User Guide on the CD-ROM. Li... »