Notice OREGON RM 313 P

« Increases or decreases the value of a setting F[ / 24hOFF ] button Sets the time for the alarm G[ ON / OFF ] button Enables or disables the alarm H[ MODE / SET ] button Toggles the display modes and confirms entry while setting the values for display IProjector For projecting the current time on the wall or ceiling J[ PROJECTION ON ] switch Used with the power adapter to enable extended use of the projector KBattery compartment Accommodates two (2) UM-3 or “AA” size batteries for operation L[ RESET ] button Resets the unit by returning all settings to factory set default values BATTERY INSTALLATION The unit uses two (2) UM-3 or “AA” size 1.5V batteries. To insert batteries: [ SEE FIG. 2 ] 1.Slide the battery door in the direction of the arrow. 2.Insert the batteries strictly according to the polarities shown therein. 3.Replace the battery compartment door. Note: Under normal circumstances, the batteries are good for 1 year. However, the battery life can be reduced vastly by frequent use of the back light, projector or snooze function. If not disposed of properly batteries can be harmful. Protect the environment by taking exhausted batteries to authorized disposal stations. HOW TO USE THE PROJECTOR Press [ ], the wall projection will be activated for approximately 5-seconds. Note: The display backlight and projection function work simultaneously. When [ ] is pressed both the backlight and projection function will activate. HOW TO USE THE PROJECTOR POWER ADAPTER Your unit comes with a power adapter so you can use the projector for extended period of time. To install the adapter: [ SEE FIG. 3 ] 1.Insert adapter into jack on the bottom of the unit. 2.Plug the adapter into the adapter socket. Note: Making sure the voltage is correct, plug the other end of the power adapter into a free wall socket. Once the power adapter is in place, you can select to turn on the projector for longer time, such as throughout the night, by sliding down the [ PROJECTION ON ] switch on the side of the unit. To turn off the projector, slide the switch back. Note that this switch can only be used with the power adapter installed. For momentary projection, use the [ ]. DISPLAY MODES The unit supports two display modes in the sequence of: Radio Controlled Kids Projection Clock RM313P / RM313PU MODE 1Local Time Hour, Minute, Seconds -------------------------------------------------- Day, Month MODE 2Local Time Hour, Minute, Day-of-the-Week -------------------------------------------------- Day, Month Display description for each time / date mode Each press on the [ MODE / SET ] will toggle the display in the above order. Note that the second line of the display will be replaced by the alarm time if the [ / 24hOFF ] BUTTON is pressed. ABOUT RADIO RECEPTION - DCF77 The RM313P is a radio frequency (RF) controlled clock. When located within a 1500km radius of radio signal (DCF77) at Frankfurt, Germany, the clock time will automatically synchronize with DCF77 time-signal transmission. The benefit of a RF controlled clock is that accurate time is maintained and manual adjustments to the time and date are not be required. (UK version within a 1500km radius of radio signal (MSF) from Rugby, England) When the batteries are first installed, the RM313P will automatically search for a radio signal. When in search mode, the antenna icon [ ] will blink. This process takes between two (2)... »