Notice BRAUN SI 4000 Easy Style disponible gratuitement après inscription

Extrait de la notice

clean. 7)Rinse under running water. 8)Re-insert the steam button. 9)Press to check the steam on/off function. Note: the iron must never be used without the steam button. GDecalcifying/anticalc system When scale particles come out of the steam vents or when the steam development is insufficient even after cleaning the anticalc valve, you should clean the steam chamber as follows: 1)Make sure the steam button is in its lower position. 2)–3) Fill water into the tank, connect to the mains and select the «•••» temperature setting. 4)–5) Wait until the pilot light turns off. Unplug the iron. 6)–7) Hold the iron over a sink, then press the steam button so it is lifted, carefully pull it up, turn it and rest it in this position. Caution: When the steam button is pulled up, hot water and steam will come out from the sole plate. 8)Push back the steam button until it catches in the lower position. 9)–10) Fill water into the tank, connect to the mains and select the «•••» temperature setting. 11)–13) When the pilot light goes off, press the power shot button 4 times to rinse the iron. Disconnect the iron and wait for the sole plate to cool off, then clean it as described above in section E. Note: the iron must never be used without the steam button. HTrouble-shooting guide ProblemRemedy –––––––––––––––––––––––––––––––––––––– Drops Turn the steam regulator coming out anti-clockwise to reduce of the steamthe steam or press the ventssteam button to turn the steam off. Take longer intervals when pressing the power shot button. Select a higher tempera- ture setting. No steamPress the steam button at allso that it is lifted. Less steamClean the anticalc valve develops or no(see F). steam at all...