TURNTABLE BELT(4A) comes attached to the PLATTER(2) and the MOTOR SPINDLE(4B) but can some times detach in shipping. Rotate the PLATTER(2) and look through the platter holes to check if the belt detached. If the belt is not wrapped tightly around the platter and the MOTOR SPINDLE(4B), you need to reattach it. 1.First, place a screwdriver in the center of LOCKING WASHER(4C) around the CENTER SPINDLE(4) and gently pry the washer off. 2.Remove the PLATTER(2) and wrap the TURNTABLE BELT(4A) around the inner circleunder the PLATTER (2). Do not stretch out the belt. 3.Replace and rotate the PLATTER(2) until the MOTOR SPINDLE (4B) is visible, then fit your fingers in hole on the top of the PLATTER (2), feel for and grab the rubber belt and attach to the MOTOR SPIN- DLE (4B). 4. Replace the LOCKING WASHER (4C). TURNTABLE INSTALLATION: 1. Put the RUBBER MAT(5) on the PLATTER(2). 2.Set the TURNTABLE BASE (1) on a flat, level surface free of vibra- tion. Use the turntable feet to horizontally stabilize the unit. 3. Try to place the unit as far away from the speakers as possible. 4.Keep the unit away from direct exposure to the sun, heat, moisture or dirt. 5. Keep the unit well ventilated. CARTRIDGE INSTALLATION: (SEE FIG. 2) Because all cartridges have their own designs, please refer to your particular cartridge’s instructions to insure proper installation. 1.Connect the lead wires to the cartridge terminals. For your convenience, the terminals of most cartridges are color coded. Connect each lead wire to the terminal of the same color. White (L+).........................................................................Left Channel + Blue (L-)............................................................................Left Channel - Red...