Notice HAMA NI-1 disponible gratuitement après inscription

Extrait de la notice

ber cover (D) from the back of the transmitter and insert one 12V/23A battery (enclosed in package). Receiver: Slide the battery-chamber cover (I) from the back of the receiver and insert two AAA 1.5v alkaline batteries (enclosed in package). gOperating instruction 00005366bda.indd 8-900005366bda.indd 8-914.10.2008 10:20:14 Uhr14.10.2008 10:20:14 UhrReplacing Batteries When replacing batteries on transmitter or receiver: 1. Check the receiver is on the “off” position 2. Turn the camera off and disconnect the receiver 3. Remove the batteries. The Low battery Indicator LED indicator on receiver blinking fast when the batteries are low, ready spare batteries. Operation 1. Turn off the camera and set the switch (F) of the receiver to “OFF”. 2. Insert the receiver end connector (K) into the remote socket of the camera, and make sure them connect ? rmly. 3. Adjust the codes on receiver and transmitter to the same position. For example: the codes on the receiver set to “1234”, and the codes on the transmitter must be the same as “1234”. 4. Set the receiver switch (F) to “ON”, and turn on the camera. 5. Extend the transmitter antenna fully. Three Modes Available: A. Single shutter (camera in single shoot mode), half-press the release button on transmitter for activating camera‘s autofocus device and light metering system, LED shows green on transmitter and receiver. Press release button completely for picture shooting, LED indicator turns red meanwhile. B. Continuous shutter (camera in continuous shoot mode), same step as single shoot, but hold the release button for taking picture continually. C. Bulb shutter (camera in Bulb shoot mode), hold release button on transmitter to start B shutter. Wh...