Notice IKEA LAGAN HGA4K disponible gratuitement après inscription

Extrait de la notice

e stated on the rating plate, corresponds to the available supply voltage. Also, check the power rating of the appliance and ensure that the wire is suitably sized to suit the appliance power rating (refer to the Technical data chapter). The rating plate is located on the lower casing of the hob. The appliance is supplied with a connection cable. This has to be provided with a proper plug, able to support the load marked on the identification plate. To connect the plug to the cable, follow the recommendation given in fol- lowing figure. 1 2 ENGLISH 9Replacement of the connection cable The replacement of the connection cable re- quires the specific equipment of a technician. In this case, only cable type H05V2V2-F T90 must be used. The cable section must be suit- able to the voltage and the working temper- ature. The yellow/green earth wire 2 must be approximately 2 cm longer than the brown (or black) phase wire 1 (previous figure). The plug has to be fitted in a proper socket. If connecting the appliance directly to the elec- tric system, it is necessary that you install a double pole switch between the appliance and the electricity supply, with a minimum gap of 3 mm between the switch contacts. The dou- ble pole has to be of a type suitable for the required load in compliance with the current rules. The connection cable has to be placed in order that, in each part, it cannot reach a 90 °C tem- perature. The blue neutral cable must be con- nected to the terminal block marked with "N". The brown (or black) phase cable (fitted in the terminal block contact marked with "L") must always be connected to the live phase. Gas setting conversion This model is designed for use with natu- ral gas but can be converted for use with butane...