hed. 3Applications This PA stereo amplifier is especially designed for the use on stage and in the discothèque. Extensive protective circuits protect the amplifier and the con- nected speakers. 4Installation The amplifier is designed to be mounted into a rack (482mm/19?), but it may also be used as a table top unit. In any case air has to move freely through all air vents so that a sufficient cooling is ensured. If the unit is to be put out of operation de - finitively, take it to a local recycling plant for a disposal which is not harmful to the envi- ronment. WARNINGThe unit is supplied with hazardous mains voltage (230V~). Never make any modifications on the unit and do not insert anything through the air vents! This may cause an electric shock. There is a hazard of contact at the speaker connections with a dangerous voltage during operation. All connec- tions must only be made or changed with the unit switched off. 4 GB D A CH5Verstärker anschließen Alle Anschlüsse dürfen nur bei ausgeschaltetem Gerät hergestellt werden! 1)An die Cinch- oder Klinkenbuchsen INPUTS (9, 10) den Ausgang eines Vorverstärkers oder eines Mischpults anschließen. Das Eingangssig- nal sollte Line-Pegel aufweisen. Für eine Vollaus- steuerung des Verstärkers ist ein Eingangssignal von mindestens 1,3V erforderlich. 2)Die größte Ausgangsleistung wird beim An - schluss von 4-O-Lautsprechern erreicht. Es kön- nen auch 8-O-Lautsprecher angeschlossen wer- den, was die Ausgangsleistung aber etwas verringert. Die Lautsprecher müssen als Nenn- belastbarkeit mindestens 200WRMS(4-O-Laut - sprecher) bzw. 125WRMS(8-O-Lautsprecher) aufweisen (vgl. Abb. 4). An die “SPEAKER”-Buchsen (8), Klinkenbuch- sen(12) oder an die Anschluss klemmen (13) die Lautsprecher a...