Notice MARMITEK MS13 disponible gratuitement après inscription

Extrait de la notice

l display the current mode (the factory setting is 1): • 1 flash for 1 minute. • 2 flashes for 2 minutes. • 3 flashes for 4 minutes. 6© MARMITEK manual MS13 05-12-2006 09:54 Pagina 6• 4 flashes for 8 minutes. • 5 flashes for 16 minutes. • 6 flashes for 32 minutes. • 7 flashes for 62 minutes. • 8 flashes for 128 minutes. • 9 flashes for 255 minutes. • Release the <unit/off> button. • Now press the <unit/off> button the number of times that corresponds to the mode that you want to set. On the last press hold down the button (e.g. for a 4-minute delay press the <unit/off> button 3 times and hold the button down on the third press) After 3 seconds the LED will display the new setting and the LED will switch off. The MS13 saves the settings in non-volatile memory so that the settings are kept when the batteries are changed. NOTE:The MS13 cannot activate alarm functions on Marmitek Alarm systems. Use the MS90 for this. FREQUENTLY ASKED QUESTIONS What is the reason for modules to switch on/off spontaneously? It is possible that a Marmitek X-10 System is installed at one of your neighbours using the same House Code. To solve this problem try to change the House Code of your system, or have FD10 Phase Coupler/Filter installed at your incoming mains. My modules will not respond to my controller. Make sure that the House Code on all Modules and Controllers are set to the same House Code (A .. P). My modules will not react to my remote / sensor. When you use a remote or sensor, you should have at least one TM13 Transceiver or Marmitek Security Console installed in your house. These components will translate the radio signals to the Marmitek X-10 signal on the power line. Only one Transceiver should be installed for all remotes and sensors set to th...