Notice NAD C325BEE disponible gratuitement après inscription

Extrait de la notice

ect the speakers to the rear Speaker terminals and sources to the relevant rear input sockets. 2Plug in the AC power cord. 3Switch to ON, the POWERbutton on the rear panel, to turn the C325BEE to standby. 4Press the front panel Standby button to turn the NAD C325BEE on. 5Press the required input selector. FRONT PANEL CONTROLS 1.Standby Button:The Standby Button turns on and to standby the C325BEE. This button will only function when the Power/Standby/Protection LED is either amber representing the standby state, or green representing the on-state. NOTE The remote control handset supplied with the C325BEE is of a universal NAD type, designed to operate several NAD models. Some buttons on this handset are inoperative, as the functions aren’t supported by the C325BEE. 2Power/Standby/Protection LED - Upon switching the power on, the LED will light up red for a few seconds before the protection circuit is deactivated. The LED will then turn green, representing normal operation. In cases of serious abuse of the amplifier, such as overheating, excessively low loudspeaker impedance, short circuit etc. the amplifier will engage its Protection circuitry, indicated by the LED turning from green to red, and the sound being muted. In such a case, turn the amplifier off by the rear panel POWERbutton, wait for it to cool down and/or check the speaker connections, making sure the overall loudspeaker impedance doesn’t go below 4 ohms. Once the cause for the protection circuitry to engage has been removed, switch ONthe rear POWERbutton and then the Standby Button to resume normal operation. 3Headphone socket - A 1/4” stereo jack socket is supplied for headphone listening and will work with conventional headphones of any impedance. Inserting a headphone jac...