Notice PHILIPS GC4710

Notice PHILIPS GC4710 disponible gratuitement après inscription

Accédez à la notice du PHILIPS GC4710 en adhérant à la communauté.

Notice d’utilisation de votre PHILIPS GC4710. La notice vous renseigne sur l’utilisation, donne des solutions aux problèmes d’entretien, de fonctionnement et d’assistance pour votre GC4710.

Notices - manuels - modes d'emploi disponibles pour PHILIPS GC4710 après inscription au groupe d'entraide

Aperçu de la notice

Extrait de la notice

it the Philips website at or contact the Philips Consumer Care Centre in your country (you ?nd its phone number in the worldwide guarantee lea?et). If there is no Consumer Care Centre in your country, go to your local Philips dealer. Frequently asked questions If the appliance does not work or does not work properly, ?rst check the list below. If the problem is not mentioned in this list, the appliance probably has a defect. In that case we advise you to take the appliance to your dealer or to an authorised Philips service centre. ProblemPossible causeSolution The iron is plugged in, but the soleplate is cold. There is a connection problem. Check the mains cord, the plug and the wall socket. The temperature dial is set to MIN. Set the temperature dial to the required position. The iron does not produce any steam. There is not enough water in the water tank. Fill the water tank (see chapter ‘Preparing for use’, section ‘Filling the water tank’). The steam control is set to position 0.Set the steam control to l or ; (see chapter ‘Preparing for use’, section ‘Selecting temperature and steam setting’). The iron is not hot enough and/or the drip-stop function has been activated. Set an ironing temperature that is suitable for steam ironing ( 2 to MAX). Put the iron on its heel and wait until the amber temperature light has gone out before you start ironing. The iron does not produce a steam boost. You have used the steam boost function too often within a short period. Continue ironing in horizontal position and wait a while before you use the steam boost function again. The iron is not hot enough.Set an ironing temperature at which the steam boost function can be used ( 3 to MA...

En cours...