Notice SCHOLTES HE4390 disponible gratuitement après inscription

Extrait de la notice

t into the room passes through non-closing openings such as air recycling wall boxes, doors, windows or with other technical measures. The use of an unprotected flame is dangerous for the filters and could cause fires. Therefore, never use an open flame under the hood. The hood must not be connected to fuel exhaust flues (boilers, heating systems, water heaters, and so on). Please, keep to the provisions of official directives regarding the question of fume discharge. The manufacturers refuse to accept any responsibility for damage to the hood or its catching on fire because of failure to observe the above instructions.GB 15 Installation Diagram 1 Fastening the hood - Diagram 1 •Place the drilling template on the wall (1) and make two holes (2). •Insert the two wall anchors (3). •Fasten the hood to the top holes (4) using two screws. •Remove the metal filters (5). •Use two screws to fasten the hood for safety purposes (6). •Fasten the support for the chimney using two wall anchors (7) and two 5 mm x 45 mm screws (8) at a distance of 3-4 mm from the ceiling so that it is perpendicular to the hood and perfectly horizontal. •Fasten the connector ring at the top of the hood using the two screws (9). •Vented version: Install an exhaust duct long enough to reach the outside (10). •Filtering version: Fasten the deflector in place by inserting two screws (9F) in the front holes and tightening them. •Use a pipe to fasten the connector ring to the deflector. •Make the electrical connection (11). (See the section on the “Electrical Connection”). •Insert the chimney (12) and fasten it to the support bracket using two screws (13). Slide the bottom part of the chimney until it fits into the seat on the top part of the hood (14).GB...