Notice SKIL F0151743AE disponible gratuitement après inscription

Extrait de la notice

!cleanandlightlylubricatetheSDS+accessory beforeinsertion - pull back locking sleeve G and insert accessory in SDS+ chuck while turning and pushing it until it engages; the accessory locks in position automatically - pull accessory to check that it is locked correctly - remove accessory by pulling back locking sleeve G !theSDS+accessoryrequiresfreedomof movementwhichcauseseccentricitywhentoolis off-load;however,theaccessoryautomatically centresitselfduringoperationwithoutaffecting drillingprecision !donotusebits/chiselswithadamagedshank • Safety clutch If the accessory gets jammed, the drive to the spindle is interrupted (causing a rattling noise) - immediately switch o? tool - remove the jammed accessory - switch on tool again • Adjusting drilling depth ! • Holding and guiding the tool @ !whileworking,alwaysholdthetoolatthe grey-colouredgriparea(s) - alwaysuseauxiliaryhandleH (can be adjusted as illustrated) - keep the ventilation slots uncovered - do not apply too much pressure on the tool; let the tool do the work for you APPLICATIONADVICE • Use the appropriate bits # !onlyusesharpbits/chisels • For drilling in wood, metal and plastic as well as for screwdriving use the corresponding adapter (SKIL accessory 2610395660) $ - clean and lightly lubricate adapter before insertion - pull back locking sleeve G 2 and insert adapter in SDS+ chuck while turning and pushing it until it engages; the adapter locks in position automatically - pull adapter to check whether is it locked correctly - set switch E 2 to normal drilling (onlyactivatewhen toolisswitchedoffandplugisdisconnected) • When drilling ferrous metals - pre-drill a smaller hole, when a large...