Notice ARGO Oscar TWIN 14

« to keep it handy for your reference. PRODUCT IDENTIFICATION 01.Control panel 02.Supply air deflector, 03.Transportation handle (both sides) 04.Return air grille (both sides) 05.Transportation wheels 06.Outdoor unit 07.Flexible tube0 08.Handle (for transportation and hanging) 09.Air filter (both sides), 10.Electric cable with plug 11.Outdoor unit hanger 12.Space for cable winding Supply air Return air CONTENTS PRODUCT IDENTIFICATION............................................................................2 CONTROL PANEL ............................................................................................3 BEFORE USING THE APPLIANCE ..................................................................3 AIR CONDITIONER INSTALLATION ...............................................................3-4 OPERATION Positioning of outdoor unit .......................................................................4 Cooling mode ..........................................................................................4 Fan only ..................................................................................................4 CARE AND CLEANING ....................................................................................5 USEFUL ADVICES ...........................................................................................5 SETTING AIR FLOW DIRECTION ...................................................................6 ACCESSORIES (SUPPLIED ON REQUEST) ..................................................6 Outdoor unit basket (for wall mountig) ....................................................6 Outdoor unit bracket (for window mounting)...........................................6 WIRING DIAGRAM ...........................................................................................7 EG3 BEFORE USING THE APPLIANCE AIR CONDITIONER INSTALLATION lCheck that the power supply at the location where the air conditioner is going to be used is 220/240 volt, single phase, 50 cycles. lMake sure that the electrical installation is suitable to supply continuosly a current of 5 A in addition to that already used by other electic appliances. lThe installation of a double-pole switch, protected by 10 Afuses of the delayed type, upstream the electricity wall socket is recommended. lThe unit has to be connected according to the local electrical rules. lMake sure that circuit breakers, fuses, etc, are of sufficient capacity to handle a start-up current of 21 A. lDo not install the air conditioner where it could be affected by drops of water (i.e. in laundries). lMake sure that the ON-OFFpush-button switch on the control panel of the air conditioner is in OFF position. lBefore connecting the air conditioner to a power socket, make sure that the socket is provided with an earth connection in compliance with local codes. lNever use the power plug as a mean to start or stop the air conditioner: always use the push-button switch on the air conditioner control panel. lThe manufacturer assumes no responsabilities if the safety regulations or local codes are not observed. lWARNING! Wait for 3 minutes after each previous stop of compressor before re-starting the appliance. Several stops and re-starting in a short time could damage the compressor. Avoid quick movements of the thermostat cursor in both directions when compressor is running. lMake sure that there are no obstacles around the indoor unit aff... »