Notice SONY MDR-EX38iP

« quipment sold in countries applying EU directives The manufacturer of this product is Sony Corporation, 1-7-1 Konan Minato-ku Tokyo, Japan. The Authorized Representative for EMC and product safety is Sony Deutschland GmbH, Hedelfinger Strasse 61, 70327 Stuttgart, Germany. For any service or guarantee matters please refer to the addresses given in separate service or guarantee documents. Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The recycling of materials will help to conserve natural resources. For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. Features ? Easy-to-use remote control (only for iPod and iPhone) ? Clear and rich sound with deep bass ? Convenient cord adjuster supplied How to use Wearing the headphones (see fig. ?) Wear the earpiece marked ? in your right ear and the one marked ? in your left ear. There is a tactile dot on the unit marked ? to distinguish the left side. How to use the cord slider (see fig. ?-?) Move up and down to change the split position of the cord. How to use the supplied cord adjuster (see fig. ?-?) You can adjust the cord length by winding the cord on the cord adjuster. (The cord can be wound to the cord adjuster up to 50 cm. If you wind more, the cord comes off from the cord adjuster easily.) 1 Wind the cord. 2 Push cord into slot hole to secure in place. Note Do not wind the plug or split section of the cord, as it will strain the cord and may cause a wire break. How to use the remote and microphone for an iPod and iPhone (see fig. ?-?) You can control a connected iPod and iPhone product. Parts and controls ? Volume + Increases the volume of the connected iPod product. ? Center button Plays/pauses a track of the connected iPod product with a single press. Skips to the next track with a double press. Skips to the previous track with a triple press. Starts the “VoiceOver*” feature with a long press (if available). Press once to answer the call. Press again to end. Hold down for about two seconds to reject an incoming call. When you let go, two low beeps confirm the call was rejected. ? Volume – Decreases the volume of the connected iPod product. ? Microphone Compatible products You can use the unit with only the following models supporting remote control. ? iPod nano 4th generation (video) ? iPod nano 5th generation (video camera) ? iPod classic 120GB 160GB (2009) ? iPod touch 2nd generation ? iPod shuffle 3rd generation ? iPhone 3GS * Availability of the “VoiceOver” feature depends on iPod and its software version. How to install the earbuds correctly (see fig. ?) If the earbuds do not fit your ears correctly, low-bass sound may not... »