Notice HOOVER TFS 7197

« uide. Please ensure that this guide is fully understood before operating the appliance. Warning: Electricity can be extremely dangerous. This appliance is double insulated and must not be earthed. Important: The wires in the mains power lead are coloured in accordance with the following code: Blue - Neutral Brown - Live Static electricity: Some carpets can cause a small build up of static electricity. Any static electric- ity discharge is not hazardous to health. Remember: After use, switch the cleaner off and remove the plug from the electricity supply. Always switch off and remove the plug before cleaning the appliance or attempting any mainte- nance. Safety with children, elderly or the in? rm: Do not let children play with the appliance or its con- trols. Please supervise the use of the appliance by older children, the elderly or the in? rm. IT IS IMPORTANT THAT YOU DO NOT Position the cleaner above you when cleaning the stairs. Use the cleaner out of doors on wet surfaces or for wet pickup. Pick up matches, hot ash, cigarette ends, hard or sharp objects or anything that may damage the cleaner. Spray with or pick up ? ammable liquids, cleaning ? uids, aerosols or their va pours as this may cause risk of ? re/explosion. Run over the supply cord whilst using the cleaner or remove the plug by pulling on the cord. Stand on or wrap the power cord around arms or legs when using the cleaner. Continue to use your cleaner if it appears to be faulty. If the supply cord is damaged, stop using the cleaner IMMEDIATELY. To avoid a hazard, an authorised Hoover service engineer must replace the supply cord. Remove the cyclonic cassette before removing the hose from the cleaner. Use the appliance to clean people or animals. ASSEMBLING YOUR CLEANER Remove the cleaner and accessories form their packaging. Please dispose of the packaging material in a safe and conscientious way. Insert the hose end into the cleaner, ensuring it clips and locks into position. To release: simply press the two buttons on the hose end and pull (P1). Fit the hose/handle and ? oor nozzle onto opposite ends of the telescopic tube (P2 & P3). The ac- cessory tools can be stored on the tool holder ? xed to the telescopic tube (P3). • • • • • • • • • 0565_5319_d2.indd Sec1:60565_5319_d2.indd Sec1:625/03/2008 12:27:1025/03/2008 12:27:10EN 7 USING YOUR CLEANER Power supply - Pull cord and plug into power supply (P4), Please make sure the cord is fully extended before using the cleaner (do not pull the cord beyond the red marker). Press the on/off pedal once to start the cleaner (P5). Press it again to stop the cleaner before removing the plug after use. Press the cord rewind button to wind the power cord back into the cleaner (P6). Fixed power control (depending on model) - Adjust the suction by moving the handle valve: suction will decrease when opening the valve (P7). Use low suction for delicate fabrics. Variable power control (depending on model) - Slide the variable power adjuster to increase or decrease the power level (P8). Use low suction for delicate fabrics. Telescopic Tube / Telescopic Tritube (depending on model) – The Telescopic Tube or Tritube can be extended or collapsed by pressing the latches forward and pulling or pushing the tubes to the desired length (P9). Carpet & Floor Nozzle - Press pedal on the nozzle to lower the brush head when cleaning hard ? oors (P10). Press the pedal... »