Notice Rosières RDR61AV

Notice Rosières RDR61AV

Mode d'emploi Rosières RDR61AV disponible.

Groupe d'entraide des utilisateurs Rosières RDR61AV
1 membre dans ce groupe pour vous aider
Trouver de l'aide en rejoignant le Groupe d'entraide des
utilisateurs de votre produit RDR61AV

Bienvenue dans le groupe d'entraide des utilisateurs
Rosières RDR61AV

Le SAV entre consommateurs du groupe d’entraide Rosières RDR61AV vous permet de recevoir des solutions aux problèmes d’utilisation, conseils d’entretien, fonctionnement et assistance pour votre Hotte Rosières. Rejoignez GRATUITEMENT le groupe d'entraide RDR61AV qui compte 1 membre(s) utilisateur(s) de ce produit. Devenir membre vous donne accès à différents services gratuits pour votre Hotte : accès au mode d'emploi PDF et à la notice RDR61AV en français Rosières RDR61AV, guide de l'utilisateur, avis consommateur et forum actif, manuel d’utilisation, photos, vidéo et informations.

Dernières actualités du groupe d'entraide Rosières RDR61AV

Nouvelles questions du forum

Lancez la discussion

Nouveaux membres

  • JeanJean1766  depuis le 28/11/2018 - Expertise (non renseigné) - Utilisateur depuis (non renseigné)

Documentation disponible sur votre produit

Notice disponible après inscription gratuite au groupe d'entraide

Manuel/Notice/Mode d'emploi | 805 K | Français
Site Web Marque | Français

Pas de vidéo disponible

« ilter, then it must be ordered andmounted. This version is used when there is no ex- haust duct for venting outdoors or when it is impossible to install one. Installation When installed, the distance between ex- tractor and hob gas burners or electric plates must be not less than 65 cm providing the total hob output does not exceed 11kw. For each kw in addiction, the distance be- tween extractor and hob gas burners must be increased of 10 cm. Electric connection Before completing any connection make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood. It is advisable to call a qualified technician to make the electrical connection.Appliance fitted with plug Connect it to a socket which conforms with current regulations. If you intend to connect it directly to the elec- tric mains, remove the plug and fit an ap- proved bipolar switch with a minimum con- tact opening of no less than 3mm. If the plug is not accessible once it has been inserted in the socket, it will however be nec- essary to fit an approved bipolar switch with a minimum contact opening of no less than 3mm.Appliance without plug Fit an approved plug or an approved bipolar switch with a minimum contact opening of not less than 3mm.The manufacturer is not liable for anyproblems caused by the user’s failure toobserver the above instructions. Fastening of shelves (optional) Fasten the four side supports I to the adjacent cabinets and place the shelf on the supports (Fig. 4). Using the hood –The hood is provided with a motor with several speeds For the best performan- ce, we recommend using the low speeds in normal conditions and the high speeds in particular cases of strong odour and vapour concentration. –We recommend starting up the hood a few minutes before cooking and keeping it running until all the odours have been eliminated. Warning! –The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. –When the hood is used at the same time of other appliances that run on energy sources other than electricity, provision must be made for an adequate air supply. –No food must be cooked flambé under- neath the hood. The use of an unprotected flame is dan- gerous for the filters and could cause fires. Therefore, never use an open flame under the hood. When frying foods, never leave the pan alone because the cooking oil could flare up. –Please, keep to the provisions of official directives regarding the question of fume discharge. –The manufacturer refuses to accept any responsibility for damage to the hood or its catching on fire because of failure to observe the above instructions. Maintenance Before performing any maintenance opera- tion, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. Metal grease filter (2 or 3 pieces) The metal grease filter lasts forever and must be washed either by hand or in the dishwasher (65°C) with suitable detergents. The grease fiilters must be washed at least once a month. Remove the filter using the handles desi- gned for this purpose by pulling the filter backwards and then downwards (Fig. 2). Let the filter dry without damaging it before putting it back into place. Carry out the above steps in... »

Activité de ce groupe d'entraide

Note moyenne du groupe
Soyez le premier à noter ce produit
Durée moyenne d’utilisation
Pas d'avis consommateur
Donnez votre avis
Aucune discussion
Lancez la discussion !
Aucune opinion sur Rosières
Donner votre opinion sur Rosières
En cours...