Notice ARISTON ASD70C

« rto it when necessary. Take it with you when you move, and should you sell this appliance or pass it on to another party, make sure that this booklet is supplied along with the dryer so that the new owner may be informed about warnings and suggestions on how theappliance works. !Read these instructions carefully; the following pages contain important information on installation and suggestions on how the appliance works.Installation 2 GBWhere to put your dryer ?Place your dryer at a distance from gas ranges, stoves, heaters, or cook tops because flames can damage the appliance. ?If you are going to install the appliance under a work counter, be sure to leave a 10mm space between the top and any other objects on or above the machine and a 15mm space between the sides and lateral furnishings or walls. This is to ensure proper air circulation. Make sure that the back vents are not obstructed. Ventilation When the dryer is in use, there has to be adequate ventilation. Make sure you put your dryer in an environment that is not damp and has proper air circulation throughout. Airflow around the dryer is essential to condense the water produced during the washing, the dryer will not operate efficiently in an enclosed space or cupboard. !We do not recommend that the dryer is installed in a cupboard but the dryer must never be installed behind a lockable door, a sliding door or a door with a hinge on the opposite side to that of the dryer door. !If using the dryer in a small or cold room some condensation could be experienced. Door Reversal Instructions The door of your dryer is reversible and can easily be changed. Exchange diagonally hinge brackets and blanking screws. Exchange door latch and catch with their opposite blanking plates (see diagram above). Door catch Door latch Hinge Hinge Water drain If your dryer is installed next to a drain the water can be plumbed into this drain. This does away with the needto empty the water container. If the dryer is stacked onto or installed next to a washing machine it can share the same drain. The height of the drain must be less than 3' (1m) from the bottom of the dryer. Remove the existing clip and hose from position shown (see diagram). Fit a suitable length of hose to the new location shown (see diagram) and refit clip. !Make sure that the hose is not squashed or kinked when the dryer is in its final location. Electrical connections Make sure of the following before you insert the plug into the the electrical socket: ?The socket must be grounded. ?The socket must be able to sustain the machines maximum power, which is indicated on the rating label (see Dryer Description). ?Power voltage must be within the values indicated on the rating label (see Dryer Description). ?The socket must be compatible with the dryers plug. Should this not be the case, replace the plug or the socket. !The dryer must not be installed outdoors, even if the space is sheltered. It can be very dangerous if it is exposed to rain or storms. !Once installed, the dryers electrical wire and plug must be within easy reach. !Do not use extension cords. !The power cord must not be bent or squashed. !The power cord supplied should be checked periodicallyand replaced by a cord specially prepared for this dryer and fitted only by authorised technicians (see Service). New or longer power cords are supplied at an extra charge by authorised de... »