Notice HAIER DW9AFM

« es to follow when using the appliance: * Never touch the dishwasher when bare foot or with wet hands or feet; * We discourage the use of extension cords and multiple sockets; * During installation, the power supply cord must not be exces- sively or dangerously bent or flattened; * If the appliance is not operating properly or maintenance must be performed, disconnect the appliance from the power supply. - Keep detergents out of the reach of children, who must also be kept away from the dishwasher when it is open. - This appliance cannot be installed outdoors, not even if the area in which it is installed is covered by a roof; it is also very dangerous to leave it exposed to the rain and elements. - Do not touch the heating element during or after a wash cycle. - Do not lean or sit on the door when it is open, as this could overturn the dishwasher. - If the appliance malfunctions, turn off water supply to the appli- ance and disconnect the plug from the wall socket. Then, con- sult the section entitled, "Troubleshooting". If you can not solve the problem, contact a service centre. - Only specialised personnel are authorised to make repairs. - Appliances which are no longer being used must be made inoperable by cutting the power supply cord and removing the door lock. - The appliance must be positioned so that the plug is accessible. - The carpet must not obstruct the opening when the appliance in- stalling on the ground with carpet. - If the supply cord is damaged ,it must be replaced by the manu facture ,its service agent of similarly qualified persons in order to avoid a hazard. .1. GB A B CDEClose-up View (Interior) A B C D Upper Rack Rack Height Adjustor Lower Rack E F G H Washing Filter Bottom Spray Arm Detergent and Rinse Aid Dispenser Salt Container Cap Technical characteristics Width45 cm Depth60 cm Height85 cm Capacity 9 standard place settings Mains water pressure 0.03-0.6 MPa Power voltage220-240V~ 50Hz 1900WTotal absorber power .2. Top Spray Arm GB.3. Salt Salt The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes utensils. The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water. Loading the Salt into the Softener Always use salt intended for use with dishwashers. The salt container is located beneath the lower rack and should be filled as follows: - Remove the lower rack and then unscrew and remove the cap from the salt container; - If you are filling the container for the first time, fill it with water; - Place the end of the funnel (supplied) into the hole and intro- duce about 2 kg of salt. It is normal for a small amount of water to come out of the container. - Carefully screw the cap back on. The salt container should be filled after about every 30 wash cycles. To prevent the formation of rust, load the salt just before begin- ning a wash cycle. Adjusting Salt Consumption The dishwasher is equipped with a system to adjust the level of salt consumption in function of the hardness of the water being used in order to optimize and customize the level of salt con- sumption while keeping it to a minimum. To adjust salt consumption level, follow these instructions: - Unscrew the cap on the salt container; - On the container there is... »