Notice THRUSTMASTER Kart Challenge

« ghtly, as you risk damaging the table clamp or the table. Connecting the pedal set 1. Connect the pedal set (10) to the pedal set connector (11). 2/8 INSTALLATION ON NINTENDO® WII™ & GAMECUBE™ 1. Switch on your console. 2. For the Wii™: Open the “Nintendo® GameCube™ Controller” hatch located on the top of your console. 3. Connect your wheel’s GameCube™ connector (13) to port #1 on your console. 4. Launch your game (for the Wii™: use your Wii Remote™ to launch and exit the game). You are now ready to play! IMPORTANT NOTES FOR NINTENDO® Wii™ You wheel will be compatible : - With most Virtual Console™ games (available for download from the Wii™ Shop Channel) - With all GameCube™ games (that are compatible with your Wii™ console). - With Wii™ games that are compatible with the GameCube controller. (Please check the back of Wii™ game boxes to verify compatibility.) The list of compatible Wii™ games can also be viewed at the following address: http://ts.thrustmaster.com/ DEFAULT MAPPING FOR BUTTONS AND PEDAL SET ON GAMECUBE™ AND WII™ By default, your pedal set corresponds to the “B” and “A” buttons. Using the MAPPING button (3), you can also program the “L / R” triggers onto the pedal set. (To do so, if necessary, modify the “control options” in your game’s interface.) 3/8 4/8 ADVANCED FUNCTIONS ADJUSTING THE WHEEL’S SENSITIVITY Your wheel’s steering has 2 sensitivity modes: - Normal sensitivity (the default mode) - High sensitivity (must be selected) • Selecting “High sensitivity” mode: Action LED Simultaneously press and release: the D-Pad (2) + the 2 UP and DOWN levers (7) OFF Your wheel’s steering is now more sensitive. (You must repeat this procedure after each restart or disconnection of your wheel.) • Selecting “Normal sensitivity” mode (the default mode): Action LED Simultaneously press and release: the D-Pad (2) + the 2 UP and DOWN levers (7) ON Your wheel’s steering has now returned to normal sensitivity (the default mode). PROGRAMMING THE WHEEL AND PEDALS Your wheel is fully programmable: - All buttons, the D-pad and the Up and Down levers can be switched between themselves. - All buttons, the D-pad and the Up and Down levers can be programmed onto the 2 pedals. • Examples of possible applications: - Switch different buttons for greater accessibility. - Program L and R buttons onto the pedals. - Program a button(s) onto one or both of the 2 pedals. • Programming procedure: Steps Action LED 1 Press and release the MAPPING button (3) FLASHES SLOWLY 2 Press and release the button to be programmed. FLASHES QUICKLY 3 Press and release the button or pedal onto which you wish to place your function. ON Your programming is now effective. • 5/8 To erase your programming: Step Action LED 1 Press and hold the MAPPING button (3) for 2 seconds. FLASHES QUICKLY AND TURNS BACK ON Your programming is now erased. • Note: Your programming is not saved: you must carry out the programming again after each restart or disconnection of your wheel. TROUBLESHOOTING AND WARNINGS • My wheel doesn’t function correctly or appears to be improperly calibrated: - Switch off your console, completely disconnect your wheel and all of its cables, then reconnect everything and restart your game. - In your game’s “Options / Con... »