Notice CANON Pixma IP6700D

« using any button on the operation panel, the LCD goes into sleep mode automatically. Press the OK button to turn on the LCD again. 4 Pull down the paper output tray. Raise the cover. Lower the inner cover. NOTE: Put your fingers in the notches in either side of the paper output tray and pull down to open it. 5 The print head holder automatically moves to the center. IMPORTANT: If the cover is left open for more than ten minutes, the print head holder moves to the right. Close and reopen the cover to return the holder to the center. Start Here Easy Setup Instructions 1Unpack the Printer 1Carefully remove all items from the box. PIXMA iP6700D Photo Printer Documentation and Software Kit PIXMA iP6700D Print Head Power Cord 3Installthe Print Head 1 Remove the print head from its package. CAUTION: There might be some transparent or light blue ink on the inside of the bag the print head comes in, or the inside of the protective cap. This has no effect on print quality. Be careful not to get ink on yourself when handling these items. 2 Remove the orange protective cap from the print head. NOTE: Do not touch the print head nozzles and the electrical contacts. 3 Firmly raise the print head lock lever until it stops into place. 4 Slide the print head into the holder. The print head will rest at a slight angle. 5 Lower the print head lock lever carefully and press it down. 4Install the Ink Tanks 1 Peel back the orange tab completely and remove the plastic wrapper from the Yellow Ink Tank (CLI-8Y). 2 Twist off and discard the orange protective cap located on the bottom of the ink tank. IMPORTANT: Do not touch the electrical contacts. NOTE: To avoid spilling ink, never press on the sides of an ink tank. Do not touch the open ink port once the protective cap is removed, as this may prevent the ink from being ejected properly. 3 Insert the yellow ink tank into the right-hand slot. Press the mark on the ink tank until it clicks into place and then its lamp lights red. 4 Insert the remaining five ink tanks into their appropriate slots. Ensure that ink tank lamps light red. 5 Close the inner cover and then the cover. The message requesting head alignment is displayed on the LCD. Go to the next step. NOTE: • The printer will perform a print head cleaning. Wait until the POWER lamp displays a steady light before proceeding. • If the Alarm lamp still lights even after the printerhas stopped making operating noises, an ink tank may not be installed properly. Open the cover and make sure that the ink tanks are installed in the correct order directed on the label. 5Align the Print Head 1 Lift open the paper support and extend the paper output tray. IMPORTANT: Be sure to close the inner cover completely, or the paper will not feed properly. 2 Pinch the paper guide and slide it to the left. Load a few sheets of blank paper into the auto sheet feeder, align the paper with the right side of the cover guide, then slide the paper guide toward the left edge of the paper. 3 Ensure that the message requesting head alignment is displayed on the LCD, select Yes using thebuttons and then press the OK button. The pattern is printed. And the print head is aligned automatically. IMPORTANT: It takes about 4 minutes to finish printing. When automatic print head alignment cannot be executed correctly, the message... »