elp on all aspects of using the camera.Page 14AXIS 215 PTZ Installation Guide Other methods of setting the IP address The table below shows the other methods available for setting or discovering the IP address. All methods are enabled by default, and all can be disabled. Set the IP address with ARP/Ping 1.Acquire an IP address on the same network segment your computer is connected to. 2.Locate the serial number (S/N) on the AXIS 215 PTZ label. 3.Open a command prompt on your computer and enter the following commands: 4.Check that the network cable is connected to the camera and then start/restart the camera, by disconnecting and reconnecting power. 5.Close the command prompt when you see ‘Reply from 192.168.0.125: ...’ or similar. 6.In your browser, type in http://<IP address> in the Location/Address field and press Enter on your keyboard. Notes: •To open a command prompt in Windows: from the Start menu, select Run... and type cmd. Click OK. •To use the ARP command on a Mac OS X, use the Terminal utility in Application > Utilities. Use in operating system Notes UPnP™ Windows (ME or XP) When enabled on your computer, the camera is automatically detected and added to “My Network Places.” BonjourMAC OSX (10.4 or later) Applicable to browsers with support for Bonjour. Navigate to the Bonjour bookmark in your browser (e.g. Safari) and click on the link to access the camera’s web pages. AXIS Dynamic DNS Service AllA free service from Axis that allows you to quickly and simply install your camera. Requires an Internet connection with no HTTP proxy. See www.axiscam.net for more information. ARP/PingAllSee below. The command must be issued within 2 minutes of connecting power to the camera. View DHCP server admin p...