Notice BLACK & DECKER Rotofil GL530 disponible gratuitement après inscription

Extrait de la notice

25 to 50 metres of line are available. For maximum reliability never put on a heavier or lighter line (eg. fishing line) which will prevent the automatic feed from functioning, cause motor failure or reduce cutting performance. How to fit a new spool of cutting line (Fig. 4 & 5) •Disconnect your trimmer from the power supply.4•Remove the spool cover by pushing the 2 spool cover tabs (16) inwards and upwards (Fig. 4), then pull off (it is not necessary to push both tabs in at the same time). The empty spool can now be withdrawn from the drive shaft. •Remove any dirt or grass that may have collected inside the spool housing and cover. •Unwind approximately 9cm (3.5") of cutting line (9) from the new spool (19) and temporarily park the cutting line end in one of the ‘L’ shaped slots to prevent the line unravelling.5 •Feed the cutting line through the eyelet and then push the spool onto the centre drive shaft while pulling the free end of the line to release it from the ‘L’ shaped slot. To fully seat the spool, rotate as necessary, taking care not to trap the cutting line underneath the spool and making sure that there is a minimum of 9cm (3.5") protruding from the spool housing. •Replace the spool cover by aligning both tabs on it (16) with the slots in the spool housing and pushing them into place. Make sure that both tabs are securely located. ENGLISH6 How to wind new line onto an empty spool (Fig. 6 & 7) 6•A maximum of 10 metres of new cutting line can be wound onto the empty spool. The spool has an ‘Indicator’ to help you avoid winding an excessive quantity of cutting line on the spool, as too much will prevent the automatic feed system from functioning. •Remove any remnant of old cutting line from the spool (19). •Push...