Notice EINHELL HGG 300 Niro disponible gratuitement après inscription

Extrait de la notice

educer with an output pressure of 300 mbar or for models HGG 200 Niro and HGG 300 Niro a pressure reducer with an output pressure of 1.5 bar in accordance with DIN 4811 Part 1, together with a liquefied gas pipe in compliance with DK 6 according to DIN 4815 Part 2. GB pressure reducer HGG 120 HGG 120 CH pressure reducer HGG 200 HGG 30010 Ventilation Caution: The heater must only be used in well ventilated areas (heater is not intended for use in enclosed spaces). The continuous presence of persons in these rooms is forbidden. If more than one heater is used in one room, be sure to provide for correspondingly more fresh air circulation. Maintenance Always first unplug the heater before any maintenance or repairs. Disconnect the gas hose from the gas cylinder. Regularly check that the gas hose and its screw connections are sealed. Only original replacement parts and hoses must be used. Hoses must meet the specifications in DIN 4815 Section 2. Adjustment of the ignition electrode should be checked as shown in the adjacent diagram. Q1On/Off switch F1Safety thermostat M1Fan motor Y1Thermoelectric ignition fuse Y2Safety solenoid valve B1Thermoelement B2Piezo ignition B3Ignition electrode B4Burner GB M M 1B 1B 4 B 3 B 2 Y 2 Y 1 F 1 L 1N1 Q 1E v /W11 GB Trouble Shooting ProblemCauseRemedy Motor doesn’t startNo electricity- Check electrical outlet - Check mains cable Piezo doesn’t igniteElectrode incorrectly adjustedCheck electrode and precisely set according to diagram No gas at burner- Gas valve is closed- Open valve - Gas cylinder is empty- New gas cylinder - Gas hose or connection leaks- Locate point of leak with soap -foam and repair Burner ignites, flame is - The thermoelement was...