Notice GEMINI TT-02 disponible gratuitement après inscription

Extrait de la notice

inals. For your convenience, the terminals of most cartridges are color-coded. Connect each lead wire to the terminal of the same color. Incase your cartridge is not marked the positive leads are the ones on top negative below, left are left, and right is right. White (L+)...................................................Left Channel + Blue (L-)......................................................Left Channel - Red (R+)..................................................Right Channel + Green (R-).................................................Right Channel - 2. Mount the cartridge in the HEADSHELL(5) and tighten it with the screws included with the cartridge. HEADSHELLINSTALLATION: Insert the HEADSHELL(5) into the front of the tubular TONE ARM (7). While holding the HEADSHELL(5) firm- ly in a horizontal position, turn the LOCKING NUT(6) counter clockwise until theHEADSHELL(5) is locked in place. COUNTERWEIGHT INSTALLATION: (SEE FIG. 2) 1. Slide the COUNTERWEIGHT(8) onto the rear of the TONE ARM(7) with the numbered stylus gauge facing forward. 2. Twist the COUNTERWEIGHT(8) counter clockwise lightly, to screw it onto the rear of the TONE ARM(7). ADJUSTING HORIZONTALZERO (0)BALANCE AND STYLUS PRESSURE: 1. Without touching the stylus tip, remove the stylus pro-tector (if your cartridge has a detachable one). 2. Release the ARM CLAMP(10) and lift the TONE ARM(7) off the ARM REST(11). 3. Counter clockwise advancement of the COUNTER(44)WEIGHT(8) will cause the cartridge side of the TONEARM(7) to be lowered; turning it clockwise will cause theopposite. Turn the COUNTERWEIGHT (8) clockwise orcounter clockwise as needed until the TONE ARM (7) isbalanced horizontally. You can easily tell this by watchingfor the point where the TONE ARM(7) “floats”...