Notice MARANTZ RC-1400 disponible gratuitement après inscription

Extrait de la notice

rsor buttons. D3 CONT: This is used to change the contrast of the LCD. It can be adjusted to one of 10 levels and is set using the cursor buttons. D4 CLOCK: This is used to set the current time. PAGE3 TIMER The macro timer setting is performed from this menu. D1 DAILY?: This is for using the timer function to execute a macro. Use DAILY when a program will be executed at the same time each day. D2 ONCE?: This is for using the timer function to execute a macro. Use ONCE when a program will be executed only once. D5 CANCEL: This is for using the setting time to cancel. PAGE4 CLONE The Clone mode settings are made from this menu. D1 RX: This is used on the receiving unit (slave) when copying all of the programmed information from another RC1400 remote control. D2 RX-S: This is used on the receiving unit (slave) when copying the programmed information for selected source from another RC1400 remote control. D3 TX: This is used on the sending unit (master) when copying information to another RC1400 remote control. 03.10.6, 4:17 PMPage 910 ENGLISH Loading Batteries Insert the three supplied batteries (AAA type) as shown in the figure below. Load the batteries with the polarity in the correct direction (plus + and minus - ends). 1Remove the back cover. 2Insert the new batteries (AAA type) with correct and polarity. 3Close until it clicks. Note: Do not use old batteries and new batteries together. This can result in corrosion or leakage of battery fluid. The supplied manganese batteries are for checking operation. Usage of alkaline batteries is recommended. When discarding batteries, be sure to follow the local regulations for your area. Do not put batteries in a fire. 0...