Notice MSI 915P Combo 2 disponible gratuitement après inscription

Extrait de la notice

ll on the CPU socket. 11. Visually inspect if the CPU is seated well into the socket, then remove the CPU Clip with 2 fingers. Then cover the load plate onto the package. 12. Press down the load lever lightly onto the load plate, and then secure the lever with the hook under retention tab. 13. Align the holes on the mainboard with the cooler. Push down the cooler until its four clips get wedged into the holes of the mainboard. 14. Press the four hooks down to fasten the cooler. Then rotate the locking switch (refer to the correct direction marked on it) to lock the hooks. 15. Turn over the mainboard to confirm that the clip-ends are correctly inserted. Note: If you want to uninstall the CPU, align the 4 points (see Point 8 for details) again and push the clip to lift up the CPU. MSI Reminds You... 1. Confirm if your CPU cooler is firmly installed before turning on your system. 2. Check the information in PC Health Status of H/W Monitor in BIOS for the CPU temperature. 3. Do not touch the CPU socket pins to avoid damaging. 4. Whenever CPU is not installed, always protect your CPU socket pin with the plastic cap covered to avoid damaging. 5. Please note that the mating/unmating durability of the CPU is 20 cycles. Therefore we suggest you do not plug/unplug the CPU too often. 6 Memory The mainboard provides two slots for 184-pin unbuffered DDR400 / 333 and two slots for 240-pin unbuffered DDR2 533/ 400 DIMMs. It supports the memory size up to 2GB DDR1 or DDR2 DIMMs. To operate properly, at least one DIMM module (DDR1 or DDR2) must be installed. Since DDR2 modules are not interchangeable with DDR1 and the DDR2 standard is not backward compatible, you should always install DDR2 memory module in DDR2 slot (DIMM1...