ium batteries. Important: ?CR-V3 lithium battery packs cannot be re-charged. ?Do not peel the label on a CR-V3 lithium battery pack. Using an AC power adapter (optional) Use an AC adapter designed for the area where the camera is used. Consult your nearest Olympus dealer or Service center for details. 1 C4000ZBasic-E1 02.6.17 10:44 AM Page 1213 EnInserting/Removing the memory card (SmartMedia) This camera uses SmartMedia card to record pictures. This manual uses the term “card” when referring to SmartMedia. Be sure to use a 3 V (3.3 V) card. Non-Olympus 3 V (3.3 V) cards must be formatted with the camera. Do not use a 5 V card or a 2 MB card. 1Make sure the camera is turned off (i.e.the mode dial is set to OFF).Open the card cover. 2 Inserting the card Insert the card fully with the contact area facing towards the monitor side.Insert until you feel it locked into place. ?Hold the card in a straight orientation to the card slot. Do not attempt to insert the card at an angle. ?Note the orientation of the card. If it is inserted incorrectly, it may become jammed. Removing the card Push in the card lightly to unlock it,then pull it out. 3Close the card cover securely until it clicks. Mode dial Card cover Power on/off 1Before turning the camera on,press the tabs on the lens cap to remove it. 2Set the mode dial to P,A/S/M/, or . ?The camera turns on. ?The lens moves out when the mode dial is not set to . 3Set the mode dial to OFF. ?The power turns off. Lens cap Mode dial 1 C4000ZBasic-E1 02.6.17 10:44 AM Page 1314 En GETTING STARTED (Cont.) Date/time setting 1Set the mode dial to P.2Press . ?The monitor turns on automatically and the top menu appears. 3Press íon the arrow pad to select MODE MENU.4Press ñto select S...