longer periods of time, as long as you follow the instructions given in the ‘Warning’ section in chapter ‘Important’. using the infracare 1 Put the mains plug in the wall socket. 2 Set the on/off switch to ‘I’ to switch on the appliance (Fig. 20). ,The power-on light goes on (Fig. 21). ,The appliance stays on for approx. 15 minutes and then automatically switches off. ,If you want to use the InfraCare longer, simply press the on/off switch again. EnglisH9cleaning Unplug the appliance and let it cool down for about 15 minutes before you clean it. Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance. 1 Clean the lamp housing, the pedestal and the tube with a moist cloth. Do not let any water run into the appliance. 2 You can clean the outside of the ?lter with a soft cloth sprinkled with some methylated spirits. storage 1 Unplug the appliance and let it cool down for about 15 minutes before you store it. 2 Turn the height adjustment ring anticlockwise to unlock it (1) and push the lamp housing down to its lowest position (2) (Fig. 15). 3 Turn the ring clockwise to ?x the lamp housing at this height (Fig. 16). -When you lift or carry the appliance, always make sure the lamp housing is in the lowest position. Also make sure that you grab one of the handgrips or the hinge of the lamp housing with one hand and the pedestal tube with the other hand (Fig. 22). To prevent unintentional unlocking of the height adjustment rings, do not put your hand on a height adjustment ring while you carry or lift the appliance. 4 Store the InfraCare in a dry place. replacement Filter The ?lter protects against exposure to undesired light. If the ?lter is damaged or...