Notice PHILIPS SRU-7060 disponible gratuitement après inscription

Extrait de la notice

m the original remote. You can store a fuction under any of the available keys of the SRU 7060, except LEARN,SELECT and SHIFT.Please,note that any function already stored under a key will be deleted. Example for VCR: Make sure you have the original VCR remote control at hand. 1Select the device mode VCR,with the SELECT key. 2Press the LEARN key and the target key on the SRU 7060 simultaneously for 5 seconds, until the VCR label blinks twice and remains lit. 3Place both remote controls on a flat surface (like a coffee table) and aim them head-to- head with about 10cm in between. 4Press the button you want to copy on the original remote control. –If the SRU 7060 has learned the code,the VCR label will blink twice to confirm the signal is stored. –If the VCR light blinks once for a longer period,the IR signal is not learned by the SRU 7060.Please,try a few times and make sure the remotes are aligned as described in step 3. Instructions for use EnglishIf the SRU 7060 cannot learn the code after several times trying, it is possible that: –The IR signal of your original device is out of range (the SRU 7060 can only learn IR signals with a carrier signal of 30-60kHz. –The memory of the SRU 7060 is full. –The SRU 7060 stopped the learning process after 20 seconds if no IR signals are found.Check if your original remote control is working correctly. Switch backlighting on or off With the backlighting of the SRU 7060 you can find the right key on your remote,even in a dimly lit room.As the backlighting consumes additional power,the battery lifetime will reduce when the backlighting is used frequently.Therefore it is possible to switch this function off. Turn on the backlighting: •Press keys 7 and 9 simultaneously for 5 seconds. –The Standby l...