e 6) Switches the function of the [PHONO/LINE] terminals. CAUTION When switching the [PHONO/LINE] selector switch, set [MASTER LEVEL] to [-8]. Note that noise may be generated and sound output at a high volume. 4 PHONO/LINE terminals (page 6) Connect a phono level output device (analog player (for MM car- tridges), etc.) or a line level output device (DJ player, etc.) here. Switch the terminals’ function according to the connected device using the [PHONO/LINE] selector switch on this unit’s rear panel. 5 CD terminals (page 6) Connect to a DJ player or other line level device. 6 CONTROL terminal (page 6) Connect using a control cord (included with Pioneer DJ players). 7 SIGNAL GND terminal (page 6) Connect an analog player’s ground wire here. This helps reduce noise when the analog player is connected. 8 AUX terminals (page 6) Connect to the output terminals of external devices (computers, portable audio sets, TVs, synthesizers, etc.). 9 MIC terminal (page 6) Connect to a microphone. a MASTER 1 terminals (page 6) Connect powered speakers, etc., here. ! Compatible with XLR connector type balanced outputs. b MASTER 2 terminals (page 6) Connect powered speakers, etc., here. ! Compatible with RCA pin-jack type unbalanced outputs. c Cord hook Hook the AC adapters’ power cord here. d Kensington security slot e PHONES jack (page 6) Connect headphones here.6En Connecting the input/output terminals ! When creating a DVS (Digital Vinyl System) combining a computer, audio interface, etc., be careful in connecting the audio interface to this unit’s input terminals and in the settings of the input selector switches. Also refer to the operating instructions of the DJ software and audio interface. Rear panel, front panel Audio outputsecti...