other areas may result in poor reception. The RDS (radio data system) function only works in areas that broadcast RDS signals for FM stations. 1Press SRC/OFF to select [RADIO]. 2Press BAND/ to select the band from [FM1], [FM2], [FM3], [MW] or [LW]. 3Press a number button (1/ to 6/). TIP The / buttons can be also used to select a preset station when [SEEK] is set to [PCH] in the FUNCTION settings (page12). The six strongest stations are stored on the number buttons (1/ to 6/). 1After selecting the band, press the M.C. dial to display the main menu. 2Turn the M.C. dial to select [FUNCTION], then press to confirm. 3Turn the M.C. dial to select [BSM], then press to confirm. To seek a station manually 1After selecting the band, press / to select a station. Press and hold / then release to seek an available station. Scanning stops when the unit receives a station. To cancel seek tuning, press /. NOTE [SEEK] needs to be set to [MAN] in the FUNCTION settings (page12). To store stations manually 1While receiving the station you want to store, press and hold one of the number buttons (1/ to 6/) until it stops flashing. Canceling the demonstration display (DEMO OFF) INITIAL settings Menu ItemDescription FM STEPSelect the FM tuning step from 100 kHz or 50 kHz. [100], [50] SP-P/O MODESelect when there is a full-range speaker connected to the rear speaker output leads and there is a subwoofer connected to the RCA output.[REAR/SUB.W] [SUB.W/SUB.W]Select when there is a passive subwoofer connected directly to the rear speaker output leads and there is a subwoofer connected to the RCA output. [REAR/REAR]Select when there are full-range speakers connected to the rear speaker output leads and RCA output. If there is a full-range speaker conne...