e heater and keep them at least 0.3m from the sides and rear. 12. A heater has hot and arcing or sparking parts inside. It must not be used in potentially dangerous locations such as flammable, explosive, chemical-laden or wet atmosphere. 13. This heater is intended for general use only. 14. Do not use the heater outdoors.. This appliance is classified IP21, its use is tolerated in volume 3 of the bathroom (see explanations below) 16 Volume 0 : This zone corresponds to the internal volume of the bath-tub or the receiver of shower. Volume 1 It is the volume located at the top of the bath- tub or the receiver of shower up to 2.25 m in height. Volume 2 : It is the volume located around the bath-tub or the receiver or shower up to 3.0m in height. Volume 3 : It is the remaining volume of the bathroom. WARNING : REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK. DO NOT USE THIS HEATER WITH ANY SOLID STATE SPEED CONTROL DEVICES. DESCRIPTION OF THE HEATER 1. Power light 2. Heater control 17 3. Termostat knob HEATER CONTROL STOP FAN ONLY LOW 1200W HIGH 2400W OPERATION : 1. Carefully remove your heater from the box and bag. OFF OFF 18 2. Make sure that the heater is in the OFF (0) position before plugging the heater into a outlet. 3. Place the heater on a firm, level surface. 4. The power light will light up when initially plugging the heater into a outlet. 5. For heater operation, set the Thermostat knob to the maximum setting (+). 6. Set Power knob to the desired heat setting. Low heat (1200W) is represented by the I and High heat (2400W) by the II. 7. For fan-only operation, without any heat output, turn Power knob to the fan se...