Notice ROTEL RCD-1072 disponible gratuitement après inscription

Extrait de la notice

ou are using a switched outlet to turn on and off your CD player, you should leave the power switch in the “on” position. When AC power is applied to the unit, it will power up in fully active mode. Output Connections The RCD-1072 gives you a choice of two dif- ferent kinds of outputs – an analog output signal from the built-in D/A converter for use with conventional analog audio components and a coax digital output which provides an un- processed digital signal for use with outboard D/A converters or digital processors. Note: To prevent loud noises that could damage your speakers, turn off all the sys- tem components when you make any signal connections. Analog Outputs [See Figure 3 for wiring illustration] A pair of standard RCA jacks supplies an analog output signal from the RCD-1072 to the source inputs of an audio preamplifier, in- tegrated amplifier, or receiver. Select high quality audio interconnect cables. Connect the left and right channel outputs of the RCD-1072 to the corresponding inputs on the preamplifier or other component. Digital Output [See Figure 4 for wiring illustration] If you are using an outboard D/A converter or other digital processor, you will need an unprocessed digital data stream from the RCD-1072. Using a standard 75 ohm coax digital cable, connect the RCD-1072’s digi- tal output to the digital input connector on the outboard D/A converter. 12 Volt Trigger Input The RCD-1072 can be activated by a 12 volt trigger signal. The trigger input accepts any control signal (AC or DC) ranging from 3 volts to 30 volts. When a cable is connected to the 12V input and a trigger signal is present, the RCD-1072 is activated. When the trigger signal is turned off, the unit goes into standby mode. The front pa...