OVIEMUSICPOWER ON / STANDBY J Foot pads WS-FV10D AUTO OFF POWERSAVE POWER LEVEL MODE I 3.5 m(11.5 ft.)3.5 m(11.5 ft.)3.5 m(11.5 ft.) WS-WV10D (for surround speakers) Setting the amplifier When connecting to an amplifier with internal multi channel decoders (Dolby Digital, DTS**, etc.), you should use the setup menus for the amplifier to specify the parameters of your speaker system. See the table below for the proper settings. For details on the setting procedure, refer to the manual that was provided with your amplifier. Select Micro Satellite Position if a Sony amplifier provides it. When “Hookup A” is used (Speaker setup) ForSet to Front speakersSMALL Center speakerSMALL Surround speakersSMALL SubwooferON (or YES) When “Hookup B” is used (Speaker setup) ForSet to Front speakersLARGE Center speakerSMALL Surround speakersSMALL SubwooferOFF (or NO) If you use the amplifier with adjustable crossover frequency, it is recommended to select 150 Hz (or close to this figure) as the crossover frequency for your front, center, and surround speakers. **“DTS” and “DTS Digital Surround” are registered trademarks of Digital Theater Systems, Inc. Listening to the sound (I) First, turn down the volume on the amplifier. The volume should be set to minimum before you begin playing the program source. 1Turn on the amplifier and select the program source. 2Press POWER on the subwoofer. The ON/STANDBY indicator on the subwoofer lights up green. 3Play the program source. Power turns on and off automatically — Auto power on/off function (J) When the subwoofer is on (i.e, the ON/STANDBY indicator lights up green) and there is no signal input for a few minutes, the ON/STANDBY indicator changes to red and the subwoofer enters power sa...