Notice SONY STR-SL40 disponible gratuitement après inscription

Extrait de la notice

on the receiver, the speaker may be short-circuited. If this happens, check the speaker connection again. Incorrect Correct Incorrect Correct (–) (+) speaker plug catcher at the “closing” position hexagon wrench continued 01GB04SPK_STRSL50.p654/24/03, 5:25 PM1112GB STR-SL50/40 4-247-584-11(1) (GB, FR, DE, ES) 45° 90° 20° B CC AA To avoid damaging your speakers Make sure that you turn down the volume before you turn off the receiver. When you turn on the receiver, the volume remains at the level you turn off the receiver. Performing initial setup operations Once you have hooked up the speakers and turned on the power, clear the receiver’s memory. Then specify the speaker parameters (size, position, etc.) and perform any other initial setup operations necessary for your system. Tip To check the audio output during settings (to set up while outputting the sound), check the connection (see page 17). Clearing the receiver’s memory Before using your receiver for the first time, or when you want to clear the receiver’s memory, do the following. 1Turn off the receiver. 2Hold down ?/1 on the receiver for 5 seconds. “INITIAL” appears in the display. The following are reset to their factory settings. •All settings in the SET UP, LEVEL and TONE menus. •The sound field memorized for each INPUT SELECTOR and preset station. •All sound field parameters. •All preset stations. •The master volume is set to “VOL MIN”. Performing initial setup operations Before using your receiver for the first time, adjust MAIN MENU parameters so that the receiver correspond to your system. For the adjustable parameters, see the table on page 39. See pages 13–17 for speaker settings and pages 29–30 for other settings. Multi channel surroun...