torque produced when using spray attachments with angled spray lance. Ensure that the power cord and the high- pressure hose are not damaged by being driven over, squashed or pulled; protect them against heat and oil. Do not touch the power cord with the high-pressure jet. If the machine is subjected to unusually high loads for which it was not designed (e.g., heavy impact or a fall), always check that it is in good condition before continuing work - refer also to the chapter "Before starting work". Also make certain that the safety mechanisms are working properly. Never continue using a machine that is not in perfect working order. Consult a servicing dealer if in doubt. Before leaving the machine: Switch off the machine – unplug the power cord. Safety equipment When the safety equipment is activated, excessive pressure is returned to the intake side of the pump via a safety valve. This safety feature has been set by the manufacturer and must not be adjusted. Warning! Never direct the high- pressure jet or water hose against the machine itself or against other electrical appliances and equipment – danger of short-circuiting! Never direct the high- pressure jet or water hose against electrical equipment, connections and power cords – dan- ger of short-circuiting! Never direct the high- pressure jet against your- self or other people, not even to clean clothing or shoes – risk of injury! The plug must be discon- nected immediately if the cord is damaged – dan- ger of electrocution!RE 108, RE 118, RE 128 PLUS English 6 After finishing work –Unplug the power plug from the socket –Disconnect water intake hose between machine and water supply Never unplug the power plug by pulling...