are also possible. Simply insert the Banana Plug connector into the corresponding terminal. Rear panel parts IMPEDANCE SELECTOR switch WARNING Do not change the IMPEDANCE SELECTOR switch setting while the power to this unit is on, otherwise this unit may be damaged. If this unit fails to turn on when the POWER switch is pressed: The IMPEDANCE SELECTOR switch may not be set to either end. If so, set the switch to either end when this unit’s power supply is completely cut off. Select the position whose requirements your speaker system meets. (Right position) If you use one pair of speakers, the impedance of each speaker must be 4? or higher. If you use two pairs of speakers, the impedance of each speaker must be 8? or higher. (Left position) If you use one pair of speakers, the impedance of each speaker must be 6? or higher. If you use two pairs of speakers, the impedance of each speaker must be 12? or higher. AC OUTLET(S) (SWITCHED) (Europe, China and General models) ......................................................3 SWITCHED OUTLETS (U.K. and Australia models).............1 SWITCHED OUTLET Use these to connect the power cords of your components to this unit. The power to the SWITCHED outlets is controlled by this unit’s POWER or STANDBY/ON switch. These outlets will supply power to any connected unit whenever this unit is turned on. The maximum power (total power consumption of components) that can be connected to the SWITCHED AC OUTLETS is 100W. GND terminal (For turntable use) Connecting the ground wire of the turntable to the GND terminal will normally minimize hum, but in some cases better results may be obtained with the ground wire disconnected. * 1* 2 * 3 A OR B : 6?MIN. /SPEAKER A B : I2?MIN. /SPEAKER...