Notice AVERMEDIA AverTV USB 2.0 Plus

« C meets the described requirements. ?Step 1 : Installing the Application For Windows XP operating system users, this would install both the application and the drivers at the same time. You may run the AverTV DVB-T USB 2.0 application upon connecting the unit to you PC (see Step 2). 1. Place the installation CD into the CD-ROM. The installation screen of the application will appear. If the screen doesn?t appear, go to MY Computer and double-click the ?CD-ROM? to start the program. 2. Click TV Utility Software to start the installation. 3. When the ?License Agreement? dialog box appears, click Yes. 4. Choose Complete to install all the software, including DVB-T USB 2.0 Application, DirectX 9.0, and Acrobat Reader and click Next. You can also choose Custom to select the software you want to install. 5. After installing the DVB-T USB 2.0 Application, the system will then install DirextX 9.0 and Acrobat Reader, just follow the on-screen instruction. 6. In the ?InstallShield Wizard Complete? dialog box, if you are instructed to restart your computer, select Yes. Then click Finish to complete the installation. NOTE: If DirectX 9.0 or above is not installed in your system, usually the installation CD will automatically install it during the process of installation. Make sure your system has DirectX 9.0 or above installed so that the TV software utility can function properly. ?Step 2 : Making the Connection Portable Antenna OR VHF/ UHF Antenna Back Pannel PC USB Cable Notebook USB Port STEP 2.1 STEP 2.2 ?Step 3 : Installing Drivers in Windows 2000 For Windows 2000, users need to follow the instructions below to complete installing drivers. 1. When the ?Found New Hardware Wizard? dialog box appears, click Cancel. 2. If a warning message about Digital Signature Not Found appears, click Yes. 3. You may be asked to restart the computer again, simply click Yes. Uninstalling Application and Drivers To remove the software and drivers, simply choose Start?Programs?AVerTV DVB-T USB2.0? Uninstaller??Remove AP and Driver??Next?OK?Finish. ENG-1 ENG-2 Remote Control After installing drivers and applications, you can use remote control to turn on/off the programs, select channels, adjust volume and so on. In addition, the remote control can function as a Remote Mouse by using the arrow keys (????) to control the mouse pointer when the software is closed. Remote Control Buttons Button Description 1. Power Turn on/off the application 2. Numeric Buttons - Select a TV channel. - Under the 16-channel preview mode, use??? ? to highlight the intended channel. 3. CH RTN Go to the previously selected channel. 4. 16-CH PREV 16-channel Preview. 5. VOL?/? Increase/decrease the volume. 6. FULL SCREEN Display TV or video in full screen. 7. AUDIO Switch between available languages. 8. PLAY ? Play the last recorded or played file. 9. STOP - End the Playback or recording. - End the Time Shift mode and return to real-time TV or Radio mode. 10. (Forward) - Advance the playback. - Jump to the teletext page of the corresponding color according to this button. 11. SLEEP - Go to the next file in the playlist. - Set the time to put your computer in Standby or Hibernate mode. - Jump to the teletext page of the corresponding color according to this button. 12. MENU Show up the Control Panel. 13. EPG Launch the Electronic Programme... »