Notice PHILIPS DC200

« iPod/USB mode ! 1 ALM/ 2 ALM –activates/confirm alarm 1/alarm 2 time setting –displays alarm 1/alarm 2 time –switches off alarm 1/alarm 2 time @ DISPLAY –shows clock/alarm times and status of the set # AUX IN jack (3.5 mm) –connects to external audio source $ POWER jack –socket for AC/DC 9V adaptor % Pigtail –improves FM reception POWER SUPPLY Mains adaptor 1 Connect the mains adaptor to the set's DC 9Vsocket and to the power socket. Helpful hints: To avoid damage to the set, use only the adaptor supplied! The power rating is located on the bottom of the set. SELF-POWERED BACK-UP The self-powered back-up conveniently allows your alarm and clock time settings to be stored for up to 10 minutes when there is a power interruption e.g. AC power failure. The complete clock radio and backlight illumination will be switched off. If power supply returns after 10 minutes and the display shows: •clock time blinking - indicates you need to re-adjust the clock time. BASIC OPERATION. Switching on the system •Press POWER. ™The system will switch to the last selected source. Switching the system to standby mode •In any source mode, press POWER. Illumination brightness Press REPEAT ALARM / BRIGHTNESSCONTROLonce or more. •The brightness of the display can be adjusted: Bright ?Low?Off ?Bright . SETTING THE CLOCK 1In standby mode, press and hold PROG/SET TIMEuntil clock digits flashes. 2 Hold down or press ¡1/2™repeatedly to set and adjust the hours. 3Press PROG/SET TIMEto confirm. ™The clock digits for the minutes flash. 4Hold down or press ¡1/2™repeatedly to set and adjust the minutes. 5Press PROG/SET TIMEto confirm. 6In clock mode, press ALBUM/PRESET -/+ 1/2to set your time zone. 7To zoom in/out the clock display, press MODE in clock mode. TUNER 1 Press SOURCErepeatedly to switch on the radio (FM only). ™Display shows the radio frequency of the last selected waveband. Your pre- set station is also shown if you are listening to a preset. (See 2) 2Adjust the sound using VOLUME 3/4. 3To select preset stations, press ALBUM/PRESET -/+ 1/2once or repeatedly. TUNING TO RADIO STATIONS 1Press and hold ¡1/2™until the frequency in the display starts changing. ™After the system tunes to a station of sufficient reception, display shows its frequency. •To tune to a weak station, press ¡1/2™ briefly and repeatedly until an optimal reception is found. To improve reception (FM): Extend and position the pigtail fully to obtain optimum reception. STORING AND USING PRESET STATIONS You can store up to 20 FM radio stations in the memory. 1Tune to your desired station (see TUNING TO RADIO STATIONS). 2 Press PROGto activate the programming, and then press ALBUM/PRESET -/+ 1 / 2 to select a desired preset number. 3Press PROGagain to confirm. 4 Press ALBUM/PRESET -/+ 1/ 2to listen to a preset station. AUTOSTORE: Automatic programming 1Press and hold PROGfor more than two seconds. ™Available radio stations will be automatically stored. USING THE ALARM GENERAL Two different alarm times can be set. This can be useful when you need to be woken up at a different time e.g. during the week and at the weekend, and you can set different wake-up modes: •Tuner mode. •iPod/USB mode. •Nature sound mode. •Buzzer mode. The gentle wake buzzer alarm increases its beep tone frequency within seconds. SETTING THE ALARM TIME AND MODE (See 3) 1In any mode, press and hold 1... »