Notice SONY ICF-C705

« procedures if: – you have an East European model. – you have cancelled the Automatic DST/Summer Time adjustment. Press DST. “” appears in the display and the time indication changes to daylight saving time (summer time). To deactivate the daylight saving time (summer time) adjustment, press DST again. Setting the brightness of the display Three levels of brightness are available by pressing BRIGHTNESS/ENTER. Operating the radio —Manual tuning 1 Press RADIO ON/BAND/AUDIO IN to turn on the radio. The display shows the band and frequency for a few seconds and then changes back to the current time.2 Press RADIO ON/BAND/AUDIO IN repeatedly to select the desired band. Each press changes the band as follows: When using FM1 or FM2 preset mode, you may listen to the radio on either mode. (See “Presetting your favourite station”.)3 Use TUNE/TIME SET + or - to tune into the desired station. The FM channel step is set to 0.1 MHz and the AM channel step is set to 10 kHz (Canada model). The FM channel step is set to 0.05 MHz* and the AM channel step is set to 9 kHz (Other models). * The FM frequency display is raised or lowered by a step of 0.1 MHz. For example, frequency 88.00 and 88.05 MHz is displayed as “88.0”. Two beeps sound when the minimum frequency of each band is received during tuning.4 Adjust volume using VOLUME. ? To turn off the radio, press RADIO OFF/ALARM RESET. ? To check the station being received, press TUNE/ TIME SET + or - or RADIO ON/BAND/AUDIO IN lightly. The display shows the band and frequency for a few seconds and then changes back to the current time. Presetting your favourite station —Preset tuning You can preset up to 10 stations in FM (5 stations in FM1, 5 stations in FM2), and 5 stations in AM. Presetting a station 1 Follow steps 1 to 4 in “Operating the radio” and manually tune into the station you wish to preset.2 Hold down the desired STATION SELECT/ PRESET 1 to 5 button until you hear two beeps. Example: To preset AM 1 260 kHz onto preset 2 button. The display shows the frequency for a few seconds and then changes back to the current time. The preset button number will remain. To preset another station, repeat these steps. To change the preset station, tune into the desired station and hold down the STATION SELECT/ PRESET 1 to 5 button until you hear two beeps. The new station will replace the previous station on the preset button. Tuning into a preset station 1 Press RADIO ON/BAND/AUDIO IN to turn on the radio.2 Press STATION SELECT/PRESET 1 to 5 where the desired station is stored.3 Adjust volume using VOLUME. After a few seconds, the display will return to the current time but the preset button number will remain. Improving the reception FM: The AC power cord functions as an FM antenna. Extend the AC power cord fully to increase reception sensitivity. AM: Rotate the unit horizontally for optimum reception. A ferrite bar AM antenna is built into the unit. Do not operate the unit over a steel desk or metal surface, as this may cause interference of reception. * There is a tactile dot beside VOLUME to show the direction to turn up the volume. A tactile dot also on TUNE/TIME SET + and STATION SELECT/PRESET 3 button. * Un point tactile situé à côté de VOLUME indique dans quel sens le volume augmente. La touche TUNE/TIME SET + et la touche STATION SELECT/PRESET 3 comportent également un po... »