Notice BROAN HD039

« stallation, before starting remove the grease filter/s: press inward on the clamp at the handle and pull the filter downward (Fig. 3/4). Installation of a utensil holder (upon request): see Figure 5A or 5B depending on the model purchased. Install the utensil holder with 4 flathead screws (supplied). Secure the 2 supports (C) to the hood, one on the left and one on the right; insert the utensil holder into these supports. Keep a good grip on it until you have installed, and secured, at least one of the 2 supports (D) at the top of the hood. Installation on the wall (Fig. 6): using the special drilling template, drill the required holes in the wall. As previously specified in the chapter “Warning” remember there must be a minimum of 650 mm between the bottom edge of the hood and the stop of the stove. Secure the metal bracket (B) to the wall using the screws and plugs (bracket, screws and plugs are all supplied with the unit). Use the 2 triangles cut into the bracket to position it precisely along the vertical axis of the hood. Then set the hood onto the bracket. Adjust the horizontal position, shifting the hood to the right or left as needed lining it up with the wall units. If the height of the hood also requires adjustment, use the special regulation screws (V) (supplied). Once regulation has been completed, finish securing the hood with 4 more screws (M): mark the points for the 4 holes on the wall, remove the hood and drill (8mm diameter holes); then use the plugs and screws to complete installation. Installation with rear panel (Fig. 7): the rear panel is positioned at the top of the stove, flush against the wall. Rest the lower edge of the panel behind the stove and anchor the upper edge to the wall using the two holes found on the panel. Insert the screws and plugs provided (A). The unit is secured to the rear panel as though it were being installed on the wall: use the supplied metal bracket (B) and the screws and plugs supplied with the panel. Securing the extension flues: basic installation requirements: – Set the electrical power supply within the space covered by the decorative flues. – If your unit is installed in an Exhaust hood, prepare the air exhaust hole. Adjust the width of the extension flue support bracket (W) using screws A indicated in Fig. 8. Then use the plugs and screws provided to secure it to the ceiling. Make certain it is aligned with the hood. For filtering hoods, the air exhaust grids are positioned in the upper part (Fig. 9). For exhaust hoods, turn the upper flue over so that the air exhaust grid is in the lower section (Fig. 10). Be very careful when handling the telescopic pipes, especially when resting these on the hood body, to prevent scratching. Exhaust hoods : connect the disposal duct to the air evacuation pipe of the hood. Use a flexible pipe and lock it to the air evacuation pipe of the hood with a metal hose clamp (pipe and clamp are not provided). Plug in the hood. Insert the telescopic flues setting them on the hood; extend the upper flue to the ceiling and secure with the 2 screws (G) - Fig. 11. Filtering hood: Take the air deflector and fit a flexible pipe to it (125 mm diameter) locking it with a metal hose clamp (pipe and clamps are not provided). Fit the air deflector to the upper flue (Fig. 12) with 4 screws. Install the reduction (provided) on the hood air outlet point (Fig. 13). Take the 2 assembled extension flues and set them on the hood;... »