Notice PHILIPS FR735

« plug, proceed as follows: •Connect the blue wire to the terminal marked N or coloured black. •Connect the brown wire to the terminal marked L or coloured red. •Do not connect either wire to the earth terminal in the plug,marked E (ore) or coloured green (or green and yellow). Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the two wires. Copyright in the U.K. Recording and playback of material may require consent. See Copyright Act 1956 and The Performer’s Protection Acts 1958 to 1972. Typeskilt finnes på apparatens bakside. Observer: Nettbryteren er sekundert innkoplet. Den innebygde netdelen er derfor ikke frakoplet nettet så lenge apparatet er tilsluttet nettkontakten. For å redusere faren for brann eller elektrisk støt, skal apparatet ikke utsettes for regn eller fuktighet. Norge DICHIARAZIONE DI CONFORMITA’ Si dichiara che gli apparecchi FR 735, FR 755 e MX 735 Philips rispondono alle prescrizioni dell’art. 2 comma 1 del D. M. 28 Agosto 1995 n. 548. Fatto a Eindhoven, il 01/04/1999 (FR 735, MX 735) Fatto a Eindhoven, il 01/05/1999 (FR 755) Philips Consumer Electronics Philips, Glaslaan 2 5616 JB Eindhoven, The Netherlands Italia 23 English....................................................4 Français.................................................24 Español.................................................44 Deutsch.................................................64 Nederlands...........................................84 EnglishFrançaisEspañolDeutschNederlands ItalianoItaliano................................................104GENERAL INFORMATION 4 This receiver is supplied including: – a remote control – 2 batteries for the remote control, size AA – a system bus cable for the CINEMA LINK connection – a loop antenna – a wire antenna – 5 loudspeakers including 5 speaker cables (MX 735 only) – a quick installation card (MX 735 only) – this instruction booklet Clean the receiver with a soft, slightly dampened, lint-free cloth. Donot use any cleaning agents as they may have a corrosive effect. Do not expose the receiver to humidity, rain, sand or excessive heat (caused by heating equipment or direct sunlight). If you have stacked the components of your system, the receiver must be on top. Place the receiver on a flat, hard, stabile surface. Do not cover any vents and leave 50 cm above and 10 cm left and right of the receiver free for ventilation. For good reception the loop antenna should not be placed on top of, or beneath VCRs, CD recorders, DVD players, TVs and other radiation sources. All redundant packing material has been omitted. We have done our utmost to make the packaging easily separable into three mono materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet). Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packing materials, exhausted batteries and old equipment. “DOLBY”, “DOLBYDIGITAL”,“PRO LOGIC” and the double-Dsymbol 2are trademarks of Dolby Laboratories. Trademark acknowledgment Environmental information Setup Maintenance Scope of supply EnglishGeneral information Scope of supply..................................................................................4 Maintenance......................................... »