Notice ROTEL RB-1070

« s and safety information in these instruc- tions and on the product itself. Follow all operating instruc- tions. Clean the enclosure only with a dry cloth or a vacuum cleaner. You must allow 10 cm or 4 inches of unobstructed clearance around the unit. Do not place the unit on a bed, sofa, rug, or similar surface that could block the ventilation slots. If the component is placed in a bookcase or cabinet, there must be ventilation of the cabinet to allow proper cooling. Keep the component away from radiators, heat registers, stoves, or any other appliance that produces heat. The unit must be connected to a power supply only of the type and voltage specified on the rear panel of the unit. Connect the component to the power outlet only with the sup- plied power supply cable or an exact equivalent. Do not modify the supplied cable in any way. Do not attempt to defeat ground- ing and/or polarization provisions. Do not use extension cords. Do not route the power cord where it will be crushed, pinched, bent at severe angles, exposed to heat, or damaged in any way. Pay particular attention to the power cord at the plug and where it exits the back of the unit. The power cord should be unplugged from the wall outlet if the unit is to be left unused for a long period of time. Immediately stop using the component and have it inspected and/or serviced by a qualified service agency if: •The power supply cord or plug has been damaged. •Objects have fallen or liquid has been spilled into the unit. •The unit has been exposed to rain. •The unit shows signs of improper operation •The unit has been dropped or damaged in any way Place the unit on a fixed, level surface strong enough to sup- port its weight. Do not place it on a moveable cart that could tip over. RB-1070 Stereo Power Amplifier3 Figure 1:Controls and Connections Commandes et branchements Bedienelemente und Anschlüsse Controlli e collegamenti Controles y Conexiones De bedieningsorganen en aansluitingen English POWER POWER AMPLIFIERRB-1070 PROTECTION BRIDGED MONO 1234 LEFTRIGHT SPEAKERS WARNING:TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. CAUTION RISK OF ELECTRIC SHOCKDO NOT OPEN WARNING: WARNING SHOCK HAZARD – DO NOT OPEN AVIS: RISQUE DE CHOC ELECTRIQUE–NE PAS OUVRIR SPEAKER IMPEDANCE STEREO 4 OHMS MINIMUM BRIDGED 8 OHMS MINIMUM POWER AMPLIFIER MODEL NO. RB-1070 POWER CONSUMPTION: 400W SERIAL NO. LEFT INPUTRIGHT INPUT 12V TRIGGER INOUTON OFF 898567104 PREAMP OUTPUTS RL ROTEL RB-1070 PREAMPLIFIER LEFTRIGHT SPEAKERS POWER AMPLIFIER MODEL NO. RB-1070 POWER CONSUMPTION: 400W SERIAL NO. LEFT INPUTRIGHT INPUT WARNING:TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. CAUTION RISK OF ELECTRIC SHOCKDO NOT OPEN WARNING: WARNING SHOCK HAZARD – DO NOT OPEN AVIS: RISQUE DE CHOC ELECTRIQUE–NE PAS OUVRIR SPEAKER IMPEDANCE STEREO 4 OHMS MINIMUM BRIDGED 8 OHMS MINIMUM 12V TRIGGER INOUTON OFF Figure 2:Stereo Connections Branchement des entrées et des enceintes en stéréo Anschlußdiagramm bei Stereobetrieb Collegamenti stereo - Ingressi e diffusori Conexión de la señal de entrada y las cajas acústicas De cinch- en luidsprekerverbindingen Figure 3:Bridged Connection Fonctionnement en mode ponté mono (“?bridgé?”) Anschlußdiagramm bei Brückenschaltung Collegamenti mono configurazione “a ponte”- Ingressi e diffusori C... »