Notice ION Audio Tailgater

« riate position for operation. 6. Make sure all input devices such as microphones, CD players, MP3 players, and linked amplifiers/PAs are turned off and volume settings are set at “zero.” 7. Connect all devices as shown above. 8. Switch everything on in the following order. i. audio input sources (i.e. microphones, instruments, CD/MP3 Players) ii. TAILGATER iii. any additional amplifiers 9. When shutting down, always reverse this operation by turning off: i. any additional amplifiers ii. TAILGATER iii. audio input sources (i.e. microphones, instruments, CD/MP3 Players) Go to http://www.ion-audio.com for product registration. OR (Cable sold separately) To input on additional TAILGATER (Cable sold separately) 2 DIAGRAM AND PARTS DESCRIPTION 1. Microphone 1 Balanced Input with Gain Control (1/4” or XLR): This jack can take either a ¼” balanced or a XLR balanced cable. 2. Instrument/Microphone 2 Input with Gain Control (1/4”): This mono input accepts a ¼” input such as a microphone, guitar, or other musical instrument. 3. iPod/Auxuliary input with Gain Control (Stereo RCA): This stereo RCA input can be used to connect a CD, MP3, or other audio source. The knob controls the level of the iPod and the RCA input. To connect to a portable device with a 1/8” headphone jack, you need a standard 1/8”-to-RCA adapter which is not included. 4. Master Volume Control: This knob controls the master volume of the TAILGATER. 5. iPod Charging Switch: Turn on iPod charging by setting this switch to the "Charge iPod" position. 6. Battery Level Indicator: While the unit is powered ON, these four lights indicate the power left in the battery. Battery life varies based on volume and usage. 7. Link Output: Connect a 1/4" stereo (TRS) cable to this line-level output to connect another amplifcation device, such as another TAILGATER. 8. Power In (IEC): Insert the included power cable here to charge the unit. Note that the TAILGATER can run off wall power while it simultaneously charges the battery. The charge indicator illuminates when the battery is charging. 9. Voltage Selector*: Set this to the correct voltage for your location's standard. 10. Power ON/OFF Switch: Turns TAILGATER on or off. Please note that while TAILGATER is connected to a power source, it does not need to be powered on to charge the battery. IMPORTANT NOTES If your sound is distorted at high volumes, please refer to the following troubleshooting scenarios: • Input is clipping: Try lowering the input gain or the volume control on your sound source or music instrument. • Output is clipping: Lower the main volume level. • There is too much bass: Try adjusting the tone or EQ control on your sound source to lower the bass level. This will allow you to play the music louder before clipping (distortion) occurs. • The link cable: is being plugged into the instrument or MIC input instead of the RCA line input. Important: With all speakers, an initial “break-in” period is needed to perform at optimal levels. To properly “break- in” your TAILGATER, play an audio source at medium volume for a few hours. SPECIFICATIONS Input Voltage: AC 100-120V/ 60Hz 220-240V/ 50Hz Output Wattage: 16W (THD: < 1%) Output Voltage: 8V/4? Frequency Response: Aux Input: 78Hz – 80kHz iPod Input: 63Hz – 77kHz Time required to fully charge the... »