Notice D-LINK DSR-500N

« ent. -One (1) DSR-500N/1000N Wireless N Services Router Appliance. -One (1) Power Cord -One (1) Console Cable (RJ45-to-DB9 Cable) -One (1) Ethernet (CAT5 UTP/Straight Through) Cable -One (1) Reference CD (CD-ROM containing product documentation in PDF format) -Two (2) Rack Mounting Brackets -Three (3) Detachable Omni-direction antennas ItemFeatureDescription ALED (Top to bottom) Power LED: Indicates the Wireless N Services Router is powered on. 5GHz WLAN LED (only available on DSR-1000N): A solid light indicates that the wireless segment is ready. This LED blinks during wireless data transmission. 2.4GHz WLAN LED: A solid light indicates that the wireless segment is ready. This LED blinks during wireless data transmission. BUSB Ports (2)It can support various USB 1.1 or 2.0 devices below: 1. Flash Disk or Hard Disk for network sharing. 2. 3G Adaptor for WAN redundant (Available on DSR-1000N only) 3. WCN Con?guration (It will be supported by future ?rmware upgrade) 4. Printer (It will be supported by future ?rmware upgrade) CWPS ButtonWi-Fi Protected Setup (WPS) System is a simpli?ed method for securing your wireless network during the “Initial setup” as well as the “Add New Device” processes. Please refer to the user manual for more detail process. DGigabit LAN port (1-4) Connect Ethernet devices, such as computers, switches and hubs. EGigabit WAN port (1-2) Two auto MDI/MDIX WAN ports are the connection for the Ethernet cable to the cable or DSL modem. The WAN2 port is a con?gurable port which can support WAN2 or DMZ port for dual WAN connec- tions or internal Server Farm purpose. FConsole PortUsed to access Command Line Interface (CLI) via RJ45-to-DB9 console Cable. Table 1. DSR-500N/1000N Front Panel Descriptions Device Status LEDs and Ethernet Port LEDs The device LEDs show information about current device status. When the device power up, the POWER/STATUS LED will show solid orange during power on process. Startup takes one minute approximately to complete, the LED will change to solid green. If you want to turn the device off and on again, we recommend you wait a few seconds between shutting it down and powering it back. The Ethernet LEDs show the status of each Ethernet port. Table 2 lists the name, color, status and description of each device LED. Figure 2. Ethernet RJ-45 Port LEDs TX/RX Status Link Speed Front Panel - DSR-500N/1000N Product Overview Note: DSR-500N supports one USB port only. Figure 1. DSR-500N/1000N Front Panel FDACEBD-Link Wireless N Services Router ? 3 ENGLISHLED Indicators ColorStatusDescription Power / Status Orange/ Green Solid Orange Device during power-on process Solid GreenCompletion of power on Blinking Orange Device is crashed and under recovery mode Blinking Green The system is defective, such ?rmware upgrades fail. Light OffThe device is power-off 2.4GHz/ 5GHz WLAN GreenSteady Green The link is good Blinking Green There is activity on this port Light OffNo link USBGreenSolid GreenThe link is good Blinking Green There is activity on this port Light OffNo link WPSBlueBlinking Blue Start to process Solid BlueThe connection is successfully established Light OffNo Link. TX/RX Status GreenLight OffNo Link. Solid GreenLink present. Blinking Green Port is sending or receiving data. LI... »